--- The FF2 driver (usbhid/hid-pidff.c) does not set the effect ID when uploading an effect. The result is that the initial upload works but subsequent uploads to modify effect parameters are all directed at the last-created effect. The targeted effect ID must be passed back to the device when effect parameters are changed. This is done at the start of "pidff_set_condition_report", "pidff_set_periodic_report" etc. based on the value of "pidff->block_load[PID_EFFECT_ BLOCK_INDEX].value[0]". This value is only ever set during pidff_request_effect_upload. The result is stored in "pidff->pid_id[effect->id]" at the end of pid_upload_effect, for later use. However, if an effect is modified and re-sent then this identifier is not being copied back from pidff->pid_id[effect->id] before sending the command to the device. The fix is to do this at the start of pidff_upload_effect. Signed-off-by: Jim Keir <jimkeir@xxxxxxxxxxxxxxxxxxx> drivers/hid/usbhid/hid-pidff.c | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/drivers/hid/usbhid/hid-pidff.c b/drivers/hid/usbhid/hid-pidff.c index 0b531c6..1b3fa70 100644 --- a/drivers/hid/usbhid/hid-pidff.c +++ b/drivers/hid/usbhid/hid-pidff.c @@ -568,6 +568,12 @@ static int pidff_upload_effect(struct input_dev *dev, struct ff_effect *effect, int type_id; int error; + pidff->block_load[PID_EFFECT_BLOCK_INDEX].value[0] = 0; + if (old && effect) { + pidff->block_load[PID_EFFECT_BLOCK_INDEX].value[0] = + pidff->pid_id[effect->id]; + } + switch (effect->type) { case FF_CONSTANT: if (!old) { -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html