On this EVM, the USB cable state has to be determined via the
ID pin tied to a GPIO line. We use the gpio-usb-extcon driver
to read the ID pin and the extcon framework to forward
the USB cable state information to the USB driver so the
controller can be configured in the right mode (host/peripheral).
Gets USB peripheral mode to work on this EVM.
Signed-off-by: Roger Quadros <rogerq@xxxxxx>
---
arch/arm/boot/dts/dra7-evm.dts | 31 +++++++++++++++++++++++++++++++
1 file changed, 31 insertions(+)
diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
index 10b725c..47d9a06 100644
--- a/arch/arm/boot/dts/dra7-evm.dts
+++ b/arch/arm/boot/dts/dra7-evm.dts
@@ -26,6 +26,16 @@
regulator-max-microvolt = <3300000>;
};
+ extcon_usb1: extcon_usb1 {
+ compatible = "linux,extcon-usb";
+ id-gpio = <&pcf_gpio_21 1 GPIO_ACTIVE_HIGH>;
+ };
+
+ extcon_usb2: extcon_usb2 {
+ compatible = "linux,extcon-usb";
+ id-gpio = <&pcf_gpio_21 2 GPIO_ACTIVE_HIGH>;
+ };
+
vtt_fixed: fixedregulator-vtt {
compatible = "regulator-fixed";
regulator-name = "vtt_fixed";
@@ -391,6 +401,19 @@
};
};
};
+
+ pcf_gpio_21: gpio@21 {
+ compatible = "ti,pcf8575";
+ reg = <0x21>;
+ lines-initial-states = <0x1408>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-parent = <&gpio6>;
+ interrupts = <11 IRQ_TYPE_EDGE_FALLING>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
};
&i2c2 {
@@ -520,6 +543,14 @@
};
};
+&omap_dwc3_1 {
+ extcon = <&extcon_usb1>;
+};
+
+&omap_dwc3_2 {
+ extcon = <&extcon_usb2>;
+};
+
&usb1 {
dr_mode = "peripheral";
pinctrl-names = "default";
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
