From: Gregory Herrero <gregory.herrero@xxxxxxxxx>
When booting with id pin grounded, dwc2 default to host mode.
Thus, force device mode prior initializing gadget part.
Else fifo init will fail since fifo values are not correct
in host mode.
Signed-off-by: Gregory Herrero <gregory.herrero@xxxxxxxxx>
---
drivers/usb/dwc2/gadget.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/usb/dwc2/gadget.c b/drivers/usb/dwc2/gadget.c
index f477709..df9080d 100644
--- a/drivers/usb/dwc2/gadget.c
+++ b/drivers/usb/dwc2/gadget.c
@@ -3675,6 +3675,19 @@ int dwc2_gadget_init(struct dwc2_hsotg *hsotg, int irq)
/* usb phy enable */
s3c_hsotg_phy_enable(hsotg);
+ /*
+ * Force Device mode before initialization.
+ * This allows correctly configuring fifo for device mode.
+ */
+ __bic32(hsotg->regs + GUSBCFG, GUSBCFG_FORCEHOSTMODE);
+ __orr32(hsotg->regs + GUSBCFG, GUSBCFG_FORCEDEVMODE);
+
+ /*
+ * According to Synopsys databook, this sleep is needed for the force
+ * device mode to take effect.
+ */
+ msleep(25);
+
s3c_hsotg_corereset(hsotg);
ret = s3c_hsotg_hw_cfg(hsotg);
if (ret) {
@@ -3684,6 +3697,9 @@ int dwc2_gadget_init(struct dwc2_hsotg *hsotg, int irq)
s3c_hsotg_init(hsotg);
+ /* Switch back to default configuration */
+ __bic32(hsotg->regs + GUSBCFG, GUSBCFG_FORCEDEVMODE);
+
hsotg->ctrl_buff = devm_kzalloc(hsotg->dev,
DWC2_CTRL_BUFF_SIZE, GFP_KERNEL);
if (!hsotg->ctrl_buff) {
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
