On 10/8/2014 8:51 AM, Yoshihiro Shimoda wrote:
Enable HS-USB device for the Lager board, defining the GPIO that the driver should check when probing. Since this board doesn't have the OTG ID pin, we assume that GP5_18 (USB0_PWEN) is an ID pin because it is 1 when the SW5 is in position 2-3 (meaning USB function) and 0 in other positions.
< snip >Index: renesas/arch/arm/boot/dts/r8a7790-lager.dts =================================================================== --- renesas.orig/arch/arm/boot/dts/r8a7790-lager.dts +++ renesas/arch/arm/boot/dts/r8a7790-lager.dts @@ -226,6 +226,11 @@ renesas,function = "usb0"; }; + hsusb_pins: usb0 { + renesas,groups = "usb0_ovc_vbus";Thank you for the v3 patch. I tested this, and kernel log said "GP_5_19 already requested".
GP5_19 is also USB0_OVC_VBUS. It's used by PCI [EO]HCI.
However, the hsusb on lager uses GP_5_18. Is this correct behavior?
Yes, this error needs to be ignored (I wrote about that in the changelog but you cut out that part). If you disable the internal PCI driver, this error will disappear.
sh-pfc e6060000.pfc: pin GP_5_19 already requested by ee090000.pci; cannot claim for e6590000.usb sh-pfc e6060000.pfc: pin-179 (e6590000.usb) status -22 sh-pfc e6060000.pfc: could not request pin 179 (GP_5_19) from group usb0_ovc_vbus on device sh-pfc
The kernel log already tells you well about the source of error.
Best regards, Yoshihiro Shimoda
WBR, Sergei -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
