(2014/10/07 20:42), Sergei Shtylyov wrote:
> On 10/7/2014 3:10 PM, Yoshihiro Shimoda wrote:
>
>> Since this board doesn't have USB ID pin, we assumes the GP5_18 (USB0_PWEN)
>> is an ID pin because the gpio is high when the SW5 is Pin 3 side.
>
>> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
>> ---
>> arch/arm/boot/dts/r8a7790-lager.dts | 5 +++++
>> 1 file changed, 5 insertions(+)
>
>> diff --git a/arch/arm/boot/dts/r8a7790-lager.dts b/arch/arm/boot/dts/r8a7790-lager.dts
>> index 719979e..011254a 100644
>> --- a/arch/arm/boot/dts/r8a7790-lager.dts
>> +++ b/arch/arm/boot/dts/r8a7790-lager.dts
>> @@ -446,3 +446,8 @@
>> };
>> };
>> };
>> +
>> +&hsusb {
>> + status = "okay";
>> + renesas,enable-gpio = <&gpio5 18 GPIO_ACTIVE_HIGH>;
>> +};
>
> As I said before, this is not enough. We need pinctrl-related props. Same is true for other boards.
Thank you very much for the point again.
Finally I understood what you said before.
I will start studying the pinctrl world.
Best regards,
Yoshihiro Shimoda
> WBR, Sergei
>
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
