On Thursday, January 23, 2014 09:22 AM, Peter Chen wrote:
On Wed, Jan 22, 2014 at 10:41:33PM +0100, Uwe Kleine-König wrote:
Hello,
On Wed, Jan 22, 2014 at 10:49:51AM +0100, Uwe Kleine-König wrote:
On Tue, Dec 03, 2013 at 04:01:50PM +0800, Chris Ruehl wrote:
usb: chipidea: hw_phymode_configure moved before ci_usb_phy_init
hw_phymode_configure configures the PORTSC registers and allow the
following phy_inits to operate on the right parameters. This fix a problem
where the UPLI (ISP1504) could not detected, because the Viewport was not
available and read the viewport return 0's only.
This patch (or a later revision of it to be more exact) made it into
mainline as cd0b42c2a6d2.
On an i.MX27 based machine I'm hitting an oops (see below) on
next-20140116 + a few patches. (I didn't switch to 3.13+ yet, as I think
not everything I need has landed there.) The oops goes away (and still
better, lsusb reports my connected devices instead of "unable to
initialize libusb: -99") when I do at least one of the following:
- set CONFIG_USB_CHIPIDEA=y instead of =m
- revert commit
cd0b42c2a6d2 (usb: chipidea: put hw_phymode_configure before ci_usb_phy_init)
I debugged that a bit further and the problem is that
hw_phymode_configure depends on the phy's clk being enabled (i.e.
usb_ipg_gate) and this is only enforced in ci_usb_phy_init (via
usb_phy_init -> usb_gen_phy_init). When CONFIG_USB_CHIPIDEA=y the init
call to disable all unused clocks wasn't run yet and so the clock is
still on as this is the boot default.
Hi Uwe,
I am a little puzzled at your platform
- Which phy you have used? ulpi phy ,internal phy or other external phy?
- If you use ulpi phy, why you still need to use nop phy driver?
Besides, according to chris patch, the ulpi can only be visited after
hw_phymode_configure?
- Do you have some hardware related operation at phy's probe? If it exists,
why not move it to phy->init?
Peter
Peter,
I think thats my fault, I send Uwe my patches which call the phy-ulpi
from the nop driver
in order to get the ISP1504 running with my board.
Its obversely wrong to call an other driver from the nop
see: [PATCH 3/3] usb: phy-generic: Add ULPI VBUS support and the
concerns from
Heikki (mail-list linux-usb)
Uwe we may work together on this.
Chris
Considering that it's already late today and that I don't know the
chipidea driver I'm sure there are people who can come up with a better
patch with less effort than me. Any volunteers?
Best regards
Uwe
--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
