On Wed, 8 Jan 2014, Greg KH wrote:
> On Wed, Jan 08, 2014 at 02:45:42PM +0800, Shen Guang wrote:
> > When we are doing compliance test with xHCI, we found that if we
> > enable CONFIG_USB_SUSPEND and plug in a bad device which causes
> > over-current condition to the root port, software will not be noticed.
> > The reason is that current code don't set hub->change_bits in
> > hub_activate() when over-current happens, and then hub_events() will
> > not check the port status because it thinks nothing changed.
> > If CONFIG_USB_SUSPEND is disabled, the interrupt pipe of the hub will
> > report the change and set hub->event_bits, and then hub_events() will
> > check what events happened.In this case over-current can be detected.
> >
> > Signed-off-by: Shen Guang <shenguang10@xxxxxxxxx>
> > ---
> > drivers/usb/core/hub.c | 3 ++-
> > 1 file changed, 2 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
> > index bd9dc35..98b5679 100644
> > --- a/drivers/usb/core/hub.c
> > +++ b/drivers/usb/core/hub.c
> > @@ -1154,7 +1154,8 @@ static void hub_activate(struct usb_hub *hub,
> > enum hub_activation_type type)
> > /* Tell khubd to disconnect the device or
> > * check for a new connection
> > */
> > - if (udev || (portstatus & USB_PORT_STAT_CONNECTION))
> > + if (udev || (portstatus & USB_PORT_STAT_CONNECTION) ||
> > + (portstatus & USB_PORT_STAT_OVERCURRENT))
> > set_bit(port1, hub->change_bits);
> >
> > } else if (portstatus & USB_PORT_STAT_ENABLE) {
> > --
> > 1.7.9.5
>
> Alan and Sarah, any objection to this patch?
It seems okay to me.
Acked-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
