On Tue, Oct 11, 2022 at 05:47:50PM +0100, Jon Hunter wrote: > > On 11/10/2022 17:16, Pali Rohár wrote: > > ... > > > I see, this is stupid mistake. PCIe config read and write operations > > needs to be 4-byte aligned, so normally it is done by calculating 4-byte > > aligned base address and then using appropriate cpu load/store > > instruction to access just defined size/offset of 4-byte config space > > register. > > > > pci-tegra.c is using common helper functions pci_generic_config_read() > > and pci_generic_config_write(), which expects final address with offset, > > and not 4-byte aligned address. > > > > I'm not sure what should be the proper fix, but for me it looks like > > that pci_generic_config_read() and pci_generic_config_write() could be > > adjusted to handle it. > > > > In any case, above patch is a regressions and I see there two options > > for now: > > > > 1) Reverting that patch > > > > 2) Adding "offset |= where & 0x3;" after the PCI_CONF1_EXT_ADDRESS() > > macro to set also lower 2 bits of accessed register. > > > > Jon, Lorenzo, what do you think? Could you test if 2) is working fine? > > > I tested 'offset |= where & 0xff' which is essentially the same as the above > and that is working and so I am sure that the above works too. However, I do > wonder if reverting is simpler because we already have a '& > ~PCI_CONF1_ENABLE' and now adding '| where & 0x3' seems to diminish the > value of this change. Hi Jon, it is unfortunate but I think we should proceed with a revert, please send it and I shall ask Bjorn to send it for one of the upcoming -rcX. Thanks, Lorenzo
