> From: Nicolin Chen
> Sent: Monday, June 6, 2022 2:19 PM
>
> Cases like VFIO wish to attach a device to an existing domain that was
> not allocated specifically from the device. This raises a condition
> where the IOMMU driver can fail the domain attach because the domain and
> device are incompatible with each other.
>
> This is a soft failure that can be resolved by using a different domain.
>
> Provide a dedicated errno from the IOMMU driver during attach that the
> reason attached failed is because of domain incompatability. EMEDIUMTYPE
> is chosen because it is never used within the iommu subsystem today and
> evokes a sense that the 'medium' aka the domain is incompatible.
>
> VFIO can use this to know attach is a soft failure and it should continue
> searching. Otherwise the attach will be a hard failure and VFIO will
> return the code to userspace.
>
> Update all drivers to return EMEDIUMTYPE in their failure paths that are
> related to domain incompatability.
Seems not all drivers are converted, e.g.:
mtk_iommu_v1_attach_device():
/* Only allow the domain created internally. */
mtk_mapping = data->mapping;
if (mtk_mapping->domain != domain)
return 0;
** the current code sounds incorrect which should return an error
s390_iommu_attach_device():
/* Allow only devices with identical DMA range limits */
} else if (domain->geometry.aperture_start != zdev->start_dma ||
domain->geometry.aperture_end != zdev->end_dma) {
rc = -EINVAL;
sprd_iommu_attach_device():
if (dom->sdev) {
pr_err("There's already a device attached to this domain.\n");
return -EINVAL;
}
gart_iommu_attach_dev():
if (gart->active_domain && gart->active_domain != domain) {
ret = -EBUSY;
arm_smmu_attach_dev():
if (!fwspec || fwspec->ops != &arm_smmu_ops) {
dev_err(dev, "cannot attach to SMMU, is it on the same bus?\n");
return -ENXIO;
}
**probably this check can be covered by next patch which moves bus ops
check into iommu core?
Thanks
Kevin
