It seems that we will have more and more pin controllers that support
PWM function on the (selected) pins. Due to it being a part of pin
controller IP the idea is to have some code that will switch the mode
and attach the corresponding driver, for example, via using it as
a library. Meanwhile, put a corresponding item to the pin_config_param
enumerator.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
include/linux/pinctrl/pinconf-generic.h | 2 ++
1 file changed, 2 insertions(+)
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 189e701832ea..e18ab3d5908f 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -80,6 +80,7 @@ struct pinctrl_map;
* operation, if several modes of operation are supported these can be
* passed in the argument on a custom form, else just use argument 1
* to indicate low power mode, argument 0 turns low power mode off.
+ * @PIN_CONFIG_MODE_PWM: this will configure the pin for PWM
* @PIN_CONFIG_OUTPUT_ENABLE: this will enable the pin's output mode
* without driving a value there. For most platforms this reduces to
* enable the output buffers and then let the pin controller current
@@ -125,6 +126,7 @@ enum pin_config_param {
PIN_CONFIG_INPUT_SCHMITT,
PIN_CONFIG_INPUT_SCHMITT_ENABLE,
PIN_CONFIG_MODE_LOW_POWER,
+ PIN_CONFIG_MODE_PWM,
PIN_CONFIG_OUTPUT_ENABLE,
PIN_CONFIG_OUTPUT,
PIN_CONFIG_PERSIST_STATE,
--
2.30.2
