Re: [PATCH v6 2/3] Input: atmel_mxt_ts - support wakeup methods

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Mar 02, 2021 at 01:21:57PM +0300, Dmitry Osipenko wrote:
> According to datasheets, chips like mXT1386 have a WAKE line, it is used
> to wake the chip up from deep sleep mode before communicating with it via
> the I2C-compatible interface.
> 
> If the WAKE line is connected to a GPIO line, the line must be asserted
> 25 ms before the host attempts to communicate with the controller. If the
> WAKE line is connected to the SCL pin, the controller will send a NACK on
> the first attempt to address it, the host must then retry 25 ms later.
> 
> Implement the wake-up methods in the driver. Touchscreen now works
> properly on devices like Acer A500 tablet, fixing problems like this:
> 
>  atmel_mxt_ts 0-004c: __mxt_read_reg: i2c transfer failed (-121)
>  atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121)
>  atmel_mxt_ts 0-004c: Trying alternate bootloader address
>  atmel_mxt_ts 0-004c: mxt_bootloader_read: i2c recv failed (-121)
>  atmel_mxt_ts: probe of 0-004c failed with error -121
> 
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> Signed-off-by: Jiada Wang <jiada_wang@xxxxxxxxxx>
> Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx>

Applied, thank you.

-- 
Dmitry



[Index of Archives]     [ARM Kernel]     [Linux ARM]     [Linux ARM MSM]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux