Re: [PATCH v9 08/10] gpu: host1x: mipi: Keep MIPI clock enabled and mutex locked till calibration done

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



07.08.2020 06:18, Sowjanya Komatineni пишет:
> 
> On 8/6/20 8:14 PM, Sowjanya Komatineni wrote:
>>
>> On 8/6/20 8:10 PM, Sowjanya Komatineni wrote:
>>>
>>> On 8/6/20 7:31 PM, Dmitry Osipenko wrote:
>>>> 06.08.2020 22:01, Sowjanya Komatineni пишет:
>>>> ...
>>>>> +int tegra_mipi_start_calibration(struct tegra_mipi_device *device)
>>>>>   {
>>>>>       const struct tegra_mipi_soc *soc = device->mipi->soc;
>>>>>       unsigned int i;
>>>>> @@ -381,12 +375,16 @@ int tegra_mipi_calibrate(struct
>>>>> tegra_mipi_device *device)
>>>>>       value |= MIPI_CAL_CTRL_START;
>>>>>       tegra_mipi_writel(device->mipi, value, MIPI_CAL_CTRL);
>>>>>   -    mutex_unlock(&device->mipi->lock);
>>>>> -    clk_disable(device->mipi->clk);
>>>>> +    /*
>>>>> +     * Wait for min 72uS to let calibration logic finish calibration
>>>>> +     * sequence codes before waiting for pads idle state to apply the
>>>>> +     * results.
>>>>> +     */
>>>>> +    usleep_range(75, 80);
>>>> Could you please explain why the ACTIVE bit can't be polled instead of
>>>> using the fixed delay? Doesn't ACTIVE bit represents the state of the
>>>> busy FSM?
>>>
>>> Based on internal discussion, ACTIVE bit gets cleared when all
>>> enabled pads calibration is done (same time as when DONE set to 1).
>>>
>>> Will request HW designer to look into design and confirm exactly when
>>> ACTIVE bit gets cleared.
>>>
>>> Will get back on this.
>>>
>> Verified with HW designer. above is correct. ACTIVE bit update happens
>> same time as DONE bit.
>>
>> Active = !(DONE)
>>
>> In case of calibration logic waiting for LP-11 where done bit does not
>> get set, ACTIVE will still be 1 and on next start trigger new
>> calibration will start
>>
> Based on internal design check from designer, as long as its in waiting
> for LP-11 stage, next calibration request can be triggered again but
> ACTIVE bit we will see it at 1. So we should check for DONE bits to
> confirm if calibration is done or not.
> 
> To start next calibration, it can take effect as long as its in wait for
> LP-11 mode.

I meant the start_calibration() will poll the ACTIVE bit (calibration
busy), while the finish_calibration() will poll the DONE bit
(calibration applied).



[Index of Archives]     [ARM Kernel]     [Linux ARM]     [Linux ARM MSM]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux