29.07.2020 20:55, Sowjanya Komatineni пишет:
>
> On 7/29/20 10:08 AM, Dmitry Osipenko wrote:
>> 28.07.2020 19:04, Sowjanya Komatineni пишет:
>> ...
>>>>> +void tegra_mipi_cancel_calibration(struct tegra_mipi_device *device)
>>>>> +{
>>>> Doesn't MIPI_CAL need to be reset here?
>>> No need to reset MIPI CAL
>> Could you please explain why. There is a calibration state-machine that
>> apparently needs to be returned into initial state, does it return by
>> itself?
>>
>> TRM says that MIPI block needs to be reset before of starting
>> calibration process. The reset is completely missing in the driver, I
>> assume it needs to be corrected with another patch.
>
> TRM documented incorrectly. There is no need to reset MIPI_CAL.
>
> MIPI CAL is FSM and it does not hang and done bit is to indicate if
> results are applied to pads or not.
>
> If we don't see done bit set meaning, MIPI CAL did not see LP-11 and
> results are not applied to pads.
But how to stop calibration from triggering on LP-11 once it has been
enabled? The reset should be needed since there is no other way to reset
the calibration state.
> Also while multiple streams can happen in parallel and we can't reset
> MIPI CAL as other CSI channel streams (using other pads) may also be
> going thru calibration process in parallel depending and also DSI pads
> also are calibrated thru same MIPI CAL controller.
Perhaps this should be the case for a shared reset control API usage.
