From: Thierry Reding <treding@xxxxxxxxxx> The Tegra210 features an instance of the Tegra I2C controller that is part of the host1x domain and typically used for camera use-cases. It uses pretty much the same programming model but the registers are laid out differently. Signed-off-by: Thierry Reding <treding@xxxxxxxxxx> --- .../devicetree/bindings/i2c/nvidia,tegra20-i2c.txt | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt b/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt index f64064f8bdc2..18c0de362451 100644 --- a/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt +++ b/Documentation/devicetree/bindings/i2c/nvidia,tegra20-i2c.txt @@ -35,6 +35,12 @@ Required properties: Due to above changes, Tegra114 I2C driver makes incompatible with previous hardware driver. Hence, tegra114 I2C controller is compatible with "nvidia,tegra114-i2c". + nvidia,tegra210-i2c-vi: Tegra210 has one I2C controller that is part of the + host1x domain and typically used for camera use-cases. This VI I2C + controller is mostly compatible with the programming model of the + regular I2C controllers with a few exceptions. The I2C registers start + at an offset of 0xc00 (instead of 0), registers are 16 bytes apart + (rather than 4) and the controller does not support slave mode. - reg: Should contain I2C controller registers physical address and length. - interrupts: Should contain I2C controller interrupts. - address-cells: Address cells for I2C device address. -- 2.24.1
