Re: [PATCH v6 2/5] phy: tegra: xusb: Add Tegra194 support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, Feb 12, 2020 at 02:11:30PM +0800, JC Kuo wrote:
> Add support for the XUSB pad controller found on Tegra194 SoCs. It is
> mostly similar to the same IP found on Tegra186, but the number of
> pads exposed differs, as do the programming sequences. Because most of
> the Tegra194 XUSB PADCTL registers definition and programming sequence
> are the same as Tegra186, Tegra194 XUSB PADCTL can share the same
> driver, xusb-tegra186.c, with Tegra186 XUSB PADCTL.
> 
> Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it
> is possible for some platforms have long signal trace that could not
> provide sufficient electrical environment for Gen 2 speed. This patch
> adds a "maximum-speed" property to usb3 ports which can be used to
> specify the maximum supported speed for any particular USB 3.1 port.
> For a port that is not capable of SuperSpeedPlus, "maximum-speed"
> property should carry "super-speed".
> 
> Signed-off-by: JC Kuo <jckuo@xxxxxxxxxx>
> ---
> Changes in v6: none
> Changes in v5:
> - re-use "maximum-speed" instead of adding "nvidia,disable-gen2"
> Changes in v4: none
> Changes in v3: none
> Changes in v2:
> - removed unnecessary #if/#endif pairs
> - introduce new soc->supports_gen2 flag which indicate whether or not
>   a soc supports USB 3.1 Gen 2 speed
> 
>  drivers/phy/tegra/Makefile        |  1 +
>  drivers/phy/tegra/xusb-tegra186.c | 73 +++++++++++++++++++++++++++++++
>  drivers/phy/tegra/xusb.c          | 17 +++++++
>  drivers/phy/tegra/xusb.h          |  5 +++
>  4 files changed, 96 insertions(+)

Acked-by: Thierry Reding <treding@xxxxxxxxxx>

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [ARM Kernel]     [Linux ARM]     [Linux ARM MSM]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux