On 17/09/2019 19:12, Ben Dooks wrote:
> If the hw_params uses a different bit or channel count, then we
> need to change both the I2S unit's CIF configuration as well as
> the APBIF one.
>
> To allow changing the APBIF, add a call to reconfigure the RX or
> TX FIFO without changing the DMA or allocation, and get the I2S
> driver to call it once the hw params have been calculate.
>
> Signed-off-by: Ben Dooks <ben.dooks@xxxxxxxxxxxxxxx>
> ---
> sound/soc/tegra/tegra30_ahub.c | 114 ++++++++++++++++++---------------
> sound/soc/tegra/tegra30_ahub.h | 5 ++
> sound/soc/tegra/tegra30_i2s.c | 2 +
> 3 files changed, 69 insertions(+), 52 deletions(-)
>
> diff --git a/sound/soc/tegra/tegra30_ahub.c b/sound/soc/tegra/tegra30_ahub.c
> index 952381260dc3..58e05ceb86da 100644
> --- a/sound/soc/tegra/tegra30_ahub.c
> +++ b/sound/soc/tegra/tegra30_ahub.c
> @@ -84,12 +84,40 @@ static int tegra30_ahub_runtime_resume(struct device *dev)
> return 0;
> }
>
> +int tegra30_ahub_setup_rx_fifo(enum tegra30_ahub_rxcif rxcif,
> + struct tegra30_ahub_cif_conf *cif_conf)
> +{
> + int channel = rxcif - TEGRA30_AHUB_RXCIF_APBIF_RX0;
> + u32 reg, val;
> +
> + pm_runtime_get_sync(ahub->dev);
> +
> + reg = TEGRA30_AHUB_CHANNEL_CTRL +
> + (channel * TEGRA30_AHUB_CHANNEL_CTRL_STRIDE);
> + val = tegra30_apbif_read(reg);
> + val &= ~(TEGRA30_AHUB_CHANNEL_CTRL_RX_THRESHOLD_MASK |
> + TEGRA30_AHUB_CHANNEL_CTRL_RX_PACK_MASK);
> + val |= (7 << TEGRA30_AHUB_CHANNEL_CTRL_RX_THRESHOLD_SHIFT) |
> + TEGRA30_AHUB_CHANNEL_CTRL_RX_PACK_EN |
> + TEGRA30_AHUB_CHANNEL_CTRL_RX_PACK_16;
> + tegra30_apbif_write(reg, val);
Aren't you just programming the same value to the APBIF here that was
previously programmed by the allocate function? I don't see the point in
moving this? What am I missing here?
Cheers
Jon
--
nvpublic
