Tegra194 has six PCIe controllers based on Synopsys DesignWare core. There are two Universal PHY (UPHY) blocks with each supporting 12(HSIO: Hisg Speed IO) and 8(NVHS: NVIDIA High Speed) lanes respectively. Controllers:0~4 use UPHY lanes from HSIO brick whereas Controller:5 uses UPHY lanes from NVHS brick. Lane mapping in HSIO UPHY brick to each PCIe controller (0~4) is controlled in XBAR module by BPMP-FW. Since PCIe core has PIPE interface, a glue module called PIPE-to-UPHY (P2U) is used to connect each UPHY lane (applicable to both HSIO and NVHS UPHY bricks) to PCIe controller This patch series - Adds support for P2U PHY driver - Adds support for PCIe host controller - Adds device tree nodes each PCIe controllers - Enables nodes applicable to p2972-0000 platform - Adds helper APIs in Designware core driver to get capability regs offset - Adds defines for new feature registers of PCIe spec revision 4 - Makes changes in DesignWare core driver to get Tegra194 PCIe working Testing done on P2972-0000 platform - Able to get PCIe link up with on-board Marvel eSATA controller - Able to get PCIe link up with NVMe cards connected to M.2 Key-M slot - Able to do data transfers with both SATA drives and NVMe cards Note - Enabling x8 slot on P2972-0000 platform requires pinmux driver for Tegra194. It is being worked on currently and hence Controller:5 (i.e. x8 slot) is disabled in this patch series. A future patch series would enable this. - This series is based on top of the following series Jisheng's patches to add support to .remove() in Designware sub-system https://patchwork.kernel.org/project/linux-pci/list/?series=98559 (Update: Jisheng's patches are now accepted and applied for v5.2) My patches made on top of Jisheng's patches to export various symbols http://patchwork.ozlabs.org/project/linux-pci/list/?series=115671 (Update: My above patch series is accepted and applied for v5.3) Changes since [v11]: * Modified the commit message of patch-3 in this series to address review comments from Lorenzo Changes since [v10]: * Removed device-tree patches from the series as they are applied to relevant Tegra specific trees by Thierry Reding. * Included older Tegra chips to extend quirk that disables MSI interrupt being used for Tegra PCIe root ports. * Addressed review comments in P2U driver file. Changes since [v9]: * Used _relaxed() versions of readl() & writel() Changes since [v8]: * Made the drivers dependent on ARCH_TEGRA_194_SOC directly * Addressed review comments from Dmitry Changes since [v7]: * Changed P2U driver file name from pcie-p2u-tegra194.c to phy-tegra194-p2u.c * Addressed review comments from Thierry and Rob Changes since [v6]: * Took care of review comments from Rob * Added a quirk to disable MSI for root ports * Removed using pcie_pme_disable_msi() API in host controller driver Changes since [v5]: * Removed patch that exports pcie_bus_config symbol * Took care of review comments from Thierry and Rob Changes since [v4]: * Removed redundant APIs in pcie-designware-ep.c file after moving them to pcie-designware.c file based on Bjorn's review comments Changes since [v3]: * Rebased on top of linux-next top of the tree * Addressed Gustavo's comments and added his Ack for some of the changes. Changes since [v2]: * Addressed review comments from Thierry Changes since [v1]: * Addressed review comments from Bjorn, Thierry, Jonathan, Rob & Kishon * Added more patches in v2 series Vidya Sagar (12): PCI: Add #defines for some of PCIe spec r4.0 features PCI: Disable MSI for Tegra root ports PCI: dwc: Perform dbi regs write lock towards the end PCI: dwc: Move config space capability search API PCI: dwc: Add ext config space capability search API dt-bindings: PCI: designware: Add binding for CDM register check PCI: dwc: Add support to enable CDM register check dt-bindings: Add PCIe supports-clkreq property dt-bindings: PCI: tegra: Add device tree support for Tegra194 dt-bindings: PHY: P2U: Add Tegra194 P2U block phy: tegra: Add PCIe PIPE2UPHY support PCI: tegra: Add Tegra194 PCIe support .../bindings/pci/designware-pcie.txt | 5 + .../bindings/pci/nvidia,tegra194-pcie.txt | 155 ++ Documentation/devicetree/bindings/pci/pci.txt | 5 + .../bindings/phy/phy-tegra194-p2u.txt | 28 + drivers/pci/controller/dwc/Kconfig | 10 + drivers/pci/controller/dwc/Makefile | 1 + .../pci/controller/dwc/pcie-designware-ep.c | 37 +- .../pci/controller/dwc/pcie-designware-host.c | 14 +- drivers/pci/controller/dwc/pcie-designware.c | 87 + drivers/pci/controller/dwc/pcie-designware.h | 12 + drivers/pci/controller/dwc/pcie-tegra194.c | 1635 +++++++++++++++++ drivers/pci/quirks.c | 53 + drivers/phy/tegra/Kconfig | 7 + drivers/phy/tegra/Makefile | 1 + drivers/phy/tegra/phy-tegra194-p2u.c | 120 ++ include/uapi/linux/pci_regs.h | 22 +- 16 files changed, 2150 insertions(+), 42 deletions(-) create mode 100644 Documentation/devicetree/bindings/pci/nvidia,tegra194-pcie.txt create mode 100644 Documentation/devicetree/bindings/phy/phy-tegra194-p2u.txt create mode 100644 drivers/pci/controller/dwc/pcie-tegra194.c create mode 100644 drivers/phy/tegra/phy-tegra194-p2u.c -- 2.17.1
