Remove multiple write enable and disable sequences of dbi registers as
Tegra194 implements writes to BAR-0 register (offset: 0x10) controlled by
DBI write-lock enable bit thereby not allowing any further writes to BAR-0
register in config space to take place. Hence enabling write permission at
the start of function and disabling the same only towards the end.
Signed-off-by: Vidya Sagar <vidyas@xxxxxxxxxx>
Reviewed-by: Thierry Reding <treding@xxxxxxxxxx>
---
Changes since [v9]:
* None
Changes since [v8]:
* None
Changes since [v7]:
* None
Changes since [v6]:
* None
Changes since [v5]:
* Moved write enable to the beginning of the API and write disable to the end
Changes since [v4]:
* None
Changes since [v3]:
* None
Changes since [v2]:
* None
Changes since [v1]:
* None
drivers/pci/controller/dwc/pcie-designware-host.c | 14 ++++++++------
1 file changed, 8 insertions(+), 6 deletions(-)
diff --git a/drivers/pci/controller/dwc/pcie-designware-host.c b/drivers/pci/controller/dwc/pcie-designware-host.c
index f93252d0da5b..d3156446ff27 100644
--- a/drivers/pci/controller/dwc/pcie-designware-host.c
+++ b/drivers/pci/controller/dwc/pcie-designware-host.c
@@ -628,6 +628,12 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
u32 val, ctrl, num_ctrls;
struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
+ /*
+ * Enable DBI read-only registers for writing/updating configuration.
+ * Write permission gets disabled towards the end of this function.
+ */
+ dw_pcie_dbi_ro_wr_en(pci);
+
dw_pcie_setup(pci);
if (!pp->ops->msi_host_init) {
@@ -650,12 +656,10 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
dw_pcie_writel_dbi(pci, PCI_BASE_ADDRESS_1, 0x00000000);
/* Setup interrupt pins */
- dw_pcie_dbi_ro_wr_en(pci);
val = dw_pcie_readl_dbi(pci, PCI_INTERRUPT_LINE);
val &= 0xffff00ff;
val |= 0x00000100;
dw_pcie_writel_dbi(pci, PCI_INTERRUPT_LINE, val);
- dw_pcie_dbi_ro_wr_dis(pci);
/* Setup bus numbers */
val = dw_pcie_readl_dbi(pci, PCI_PRIMARY_BUS);
@@ -687,15 +691,13 @@ void dw_pcie_setup_rc(struct pcie_port *pp)
dw_pcie_wr_own_conf(pp, PCI_BASE_ADDRESS_0, 4, 0);
- /* Enable write permission for the DBI read-only register */
- dw_pcie_dbi_ro_wr_en(pci);
/* Program correct class for RC */
dw_pcie_wr_own_conf(pp, PCI_CLASS_DEVICE, 2, PCI_CLASS_BRIDGE_PCI);
- /* Better disable write permission right after the update */
- dw_pcie_dbi_ro_wr_dis(pci);
dw_pcie_rd_own_conf(pp, PCIE_LINK_WIDTH_SPEED_CONTROL, 4, &val);
val |= PORT_LOGIC_SPEED_CHANGE;
dw_pcie_wr_own_conf(pp, PCIE_LINK_WIDTH_SPEED_CONTROL, 4, val);
+
+ dw_pcie_dbi_ro_wr_dis(pci);
}
EXPORT_SYMBOL_GPL(dw_pcie_setup_rc);
--
2.17.1
