Re: [PATCH V3 01/20] dt-bindings: clock: tegra124-dfll: Update DFLL binding for PWM regulator

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 18/12/2018 09:12, Joseph Lo wrote:
> From: Peter De Schrijver <pdeschrijver@xxxxxxxxxx>
> 
> Add new properties to configure the DFLL PWM regulator support.
> 
> Cc: devicetree@xxxxxxxxxxxxxxx
> Signed-off-by: Peter De Schrijver <pdeschrijver@xxxxxxxxxx>
> Signed-off-by: Joseph Lo <josephl@xxxxxxxxxx>
> ---
> *V3:
>  - no change
> *V2:
>  - update the binding strings and descriptions for
>  nvidia,pwm-tristate-microvolts
>  nvidia,pwm-min-microvolts
>  nvidia,pwm-voltage-step-microvolts
> ---
>  .../bindings/clock/nvidia,tegra124-dfll.txt   | 79 ++++++++++++++++++-
>  1 file changed, 77 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt b/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt
> index dff236f524a7..38e8cc8c70a8 100644
> --- a/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt
> +++ b/Documentation/devicetree/bindings/clock/nvidia,tegra124-dfll.txt
> @@ -8,7 +8,6 @@ the fast CPU cluster. It consists of a free-running voltage controlled
>  oscillator connected to the CPU voltage rail (VDD_CPU), and a closed loop
>  control module that will automatically adjust the VDD_CPU voltage by
>  communicating with an off-chip PMIC either via an I2C bus or via PWM signals.
> -Currently only the I2C mode is supported by these bindings.
>  
>  Required properties:
>  - compatible : should be "nvidia,tegra124-dfll"
> @@ -45,10 +44,31 @@ Required properties for the control loop parameters:
>  Optional properties for the control loop parameters:
>  - nvidia,cg-scale: Boolean value, see the field DFLL_PARAMS_CG_SCALE in the TRM.
>  
> +Optional properties for mode selection:
> +- nvidia,pwm-to-pmic: Use PWM to control regulator rather then I2C.
> +
>  Required properties for I2C mode:
>  - nvidia,i2c-fs-rate: I2C transfer rate, if using full speed mode.
>  
> -Example:
> +Required properties for PWM mode:
> +- nvidia,pwm-period: period of PWM square wave in microseconds.
> +- nvidia,pwm-tristate-microvolts: Regulator voltage in micro volts when PWM
> +  control is disabled and the PWM output is tristated. Note that this voltage is
> +  configured in hardware, typically via a resistor divider.
> +- nvidia,pwm-min-microvolts: Regulator voltage in micro volts when PWM control
> +  is enabled and PWM output is low. Hence, this is the minimum output voltage
> +  that the regulator supports when PWM control is enabled.
> +- nvidia,pwm-voltage-step-microvolts: Voltage increase in micro volts
> +  corresponding to a 1/33th increase in duty cycle. Eg the voltage for 2/33th
> +  duty cycle would be: nvidia,pwm-min-microvolts +
> +  nvidia,pwm-voltage-step-microvolts * 2.
> +- pinctrl-0: I/O pad configuration when PWM control is enabled.
> +- pinctrl-1: I/O pad configuration when PWM control is disabled.
> +- pinctrl-names: must include the following entries:
> +  - dvfs_pwm_enable: I/O pad configuration when PWM control is enabled.
> +  - dvfs_pwm_disable: I/O pad configuration when PWM control is disabled.
> +
> +Example for I2C:
>  
>  clock@70110000 {
>          compatible = "nvidia,tegra124-dfll";
> @@ -76,3 +96,58 @@ clock@70110000 {
>  
>          nvidia,i2c-fs-rate = <400000>;
>  };
> +
> +Example for PWM:
> +
> +clock@70110000 {
> +	compatible = "nvidia,tegra124-dfll";
> +	reg = <0 0x70110000 0 0x100>, /* DFLL control */
> +	      <0 0x70110000 0 0x100>, /* I2C output control */
> +	      <0 0x70110100 0 0x100>, /* Integrated I2C controller */
> +	      <0 0x70110200 0 0x100>; /* Look-up table RAM */
> +	interrupts = <GIC_SPI 62 IRQ_TYPE_LEVEL_HIGH>;
> +	clocks = <&tegra_car TEGRA210_CLK_DFLL_SOC>,
> +	         <&tegra_car TEGRA210_CLK_DFLL_REF>,
> +		 <&tegra_car TEGRA124_CLK_I2C5>;;
> +	clock-names = "soc", "ref", "i2c";
> +	resets = <&tegra_car TEGRA124_RST_DFLL_DVCO>;
> +	reset-names = "dvco";
> +	#clock-cells = <0>;
> +	clock-output-names = "dfllCPU_out";
> +
> +	nvidia,sample-rate = <25000>;
> +	nvidia,droop-ctrl = <0x00000f00>;
> +	nvidia,force-mode = <1>;
> +	nvidia,cf = <6>;
> +	nvidia,ci = <0>;
> +	nvidia,cg = <2>;
> +
> +	nvidia,pwm-min-microvolts = <708000>; /* 708mV */
> +	nvidia,pwm-period = <2500>; /* 2.5us */
> +	nvidia,pwm-to-pmic;
> +	nvidia,pwm-tristate-microvolts = <1000000>;
> +	nvidia,pwm-voltage-step-microvolts = <19200>; /* 19.2mV */
> +
> +	pinctrl-names = "dvfs_pwm_enable", "dvfs_pwm_disable";
> +	pinctrl-0 = <&dvfs_pwm_active_state>;
> +	pinctrl-1 = <&dvfs_pwm_inactive_state>;
> +};
> +
> +/* pinmux nodes added for completeness. Binding doc can be found in:
> + * Documentation/devicetree/bindings/pinctrl/nvidia,tegra210-pinmux.txt
> + */
> +
> +pinmux: pinmux@700008d4 {
> +	dvfs_pwm_active_state: dvfs_pwm_active {
> +		dvfs_pwm_pbb1 {
> +			nvidia,pins = "dvfs_pwm_pbb1";
> +			nvidia,tristate = <TEGRA_PIN_DISABLE>;
> +		};
> +	};
> +	dvfs_pwm_inactive_state: dvfs_pwm_inactive {
> +		dvfs_pwm_pbb1 {
> +			nvidia,pins = "dvfs_pwm_pbb1";
> +			nvidia,tristate = <TEGRA_PIN_ENABLE>;
> +		};
> +	};
> +};
> 

Acked-by: Jon Hunter <jonathanh@xxxxxxxxxx>

Cheers
Jon

-- 
nvpublic



[Index of Archives]     [ARM Kernel]     [Linux ARM]     [Linux ARM MSM]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux