On 10 August 2018 at 20:13, Aapo Vienamo <avienamo@xxxxxxxxxx> wrote: > Hi all, > This series implements support for HS400 signaling on Tegra210 and > Tegra186. This includes programming the DQS trimmer values, implementing > enhanced strobe and HS400 delay line calibration. > > This series depends on the "Tegra SDHCI add support for HS200 and UHS > signaling" series. > > Changelog: > v2: > - Document in dt-bindings which controllers support HS400 > - Use val instead of reg in tegra_sdhci_set_dqs_trim() > - Change "dt" to "DT" in "mmc: tegra: Parse and program DQS trim > value" commit message > - Add spaces around << in tegra_sdhci_set_dqs_trim() > - Make the "mmc: tegra: Implement HS400 enhanced strobe" commit > message more detailed > - Remove a debug print from tegra_sdhci_hs400_enhanced_strobe() > - Add blank lines around if-else-block in > tegra_sdhci_hs400_enhanced_strobe() > - Use val instead of reg in tegra_sdhci_hs400_enhanced_strobe() > - Make commit message of "mmc: tegra: Implement HS400 delay line > calibration" more detailed > > Aapo Vienamo (8): > dt-bindings: mmc: Add DQS trim value to Tegra SDHCI > mmc: tegra: Parse and program DQS trim value > mmc: tegra: Implement HS400 enhanced strobe > mmc: tegra: Implement HS400 delay line calibration > arm64: dts: tegra186: Add SDMMC4 DQS trim value > arm64: dts: tegra210: Add SDMMC4 DQS trim value > arm64: dts: tegra186: Enable HS400 > arm64: dts: tegra210: Enable HS400 > > .../bindings/mmc/nvidia,tegra20-sdhci.txt | 4 ++ > arch/arm64/boot/dts/nvidia/tegra186.dtsi | 2 + > arch/arm64/boot/dts/nvidia/tegra210.dtsi | 2 + > drivers/mmc/host/sdhci-tegra.c | 84 +++++++++++++++++++++- > 4 files changed, 89 insertions(+), 3 deletions(-) > > -- > 2.7.4 > Applied patch 1->4 for next, thanks! Kind regards Uffe
