On Fri, Jul 20, 2018 at 1:16 PM Jon Hunter <jonathanh@xxxxxxxxxx> wrote: > Adding Linus ... OMG this sounds bad. > >> I don't know offhand. Doesn't look like it if you have custom values. > > > > It's listed under "Supported generic properties" in > > pinctrl-bindings.txt. The convention seems to be not to add a vendor > > prefix even though such custom macro values are used. The property is > > currently used by qcom,pmic-gpio, qcom,pmic-mpp, and renesas,pfc-pinctrl. > > I could not find a bindings document describing it with a vendor prefix. > > Looking at other users of the 'power-source' property it is not clear to > me if the values should/can be vendor specific or not. I see cases where > some people use definitions and others use actual voltages. > > Linus, any recommendations here? It's a bit of imperfect world here. I always imagines it was some kind of enumerator like source A, B or C... so 0, 1 defined in sime include/dt-bindings/* would make most sense to me. In general, use SI-units if you can, else use something that makes sense for the people writing the device tree. These enumerators seems to make sense. If nothing makes any sense, maybe a custom property makes it make sense. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
