On 7/28/2018 6:13 AM, Dmitry Osipenko wrote:
On Friday, 27 July 2018 23:19:53 MSK Peter Geis wrote:
Kingston KE4CN3K6A.
Though I am pretty sure I've figured out the instability.
Brought it in to work and hooked it to a scope.
Couldn't find clock, but cmd and all eight bits are running at 1.2 volts.
Repeated the results with the bootloader, the original kernel, and my
mainline.
Also noticed that even on the slowest slew rate there is significant
ringing and overshoot of .15 volts.
Okay, but eMMC is working fine with the original kernel, isn't it?
Correct, at roughly double the speed of the mainline kernel.
According to the mmc spec, in high voltage mode it should have 2.7-3.3
volts in, and the minimum signal voltage should be .75 of that, which
equates to a minimum voltage of over 2 volts.
For low voltage mode, it should be 1.8 volts in, with the signals being
between .3 and .7 volts.
Signal voltage of 1.3 volts is .75 of 1.8, which means we have low
voltage in, but high voltage signaling.
This is even with HS-200 or DDR-1.8 assigned in the controller mode, so
for some reason we aren't switching modes.
The original kernel was running in SDR 25 signaling, but didn't try to
switch either.
Digging through the old code and the TRM, there are three ideas stuck in
my head.
The original pinmux driver had settings such as low voltage divider and
two values for each pull direction.
The pinmux driver is io resetting specifically the pads we are using,
dumping any values the bootloader had set.
Is it possible the tap configuration is not working?
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
