On Tue, Jul 03, 2018 at 09:59:47AM +0100, Jon Hunter wrote:
> On all versions of Tegra30 Cardhu, the reset signal to the NXP PCA9546
> I2C mux is connected to the Tegra GPIO BB0. Currently, this pin on the
> Tegra is not configured as a GPIO but as a special-function IO (SFIO)
> that is multiplexing the pin to an I2S controller. On exiting system
> suspend, I2C commands sent to the PCA9546 are failing because there is
> no ACK. Although it is not possible to see exactly what is happening
> to the reset during suspend, by ensuring it is configured as a GPIO
> and driven high, to de-assert the reset, the failures are no longer
> seen.
>
> Please note that this GPIO is also used to drive the reset signal
> going to the camera connector on the board. However, given that there
> is no camera support currently for Cardhu, this should not have any
> impact.
>
> Fixes: 40431d16ff11 ("ARM: tegra: enable PCA9546 on Cardhu")
>
> Cc: stable@xxxxxxxxxxxxxxx
>
> Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx>
> ---
> arch/arm/boot/dts/tegra30-cardhu.dtsi | 1 +
> 1 file changed, 1 insertion(+)
Applied to for-4.19/arm/dt, thanks.
Thierry
Attachment:
signature.asc
Description: PGP signature
