Adding Chris to CC.
Jon
On 09/10/15 14:49, Jon Hunter wrote:
> Commit 853a699739fe ("serial: tegra: handle race condition on uart rx
> side") attempted to fix a race condition between the RX end of
> transmission interrupt and RX DMA completion callback. Despite this
> fix there is still another case where these two paths can race and
> result in duplicated data. The race condition is as follows:
>
> 1. DMA completion interrupt occurs and schedules tasklet to call DMA
> callback.
> 2. DMA callback for the UART driver starts to execute. This will copy
> the data from the DMA buffer and restart the DMA. This is done under
> uart port spinlock.
> 3. During the callback, UART interrupt is raised for end of receive. The
> UART ISR runs and waits to acquire port spinlock held by the DMA
> callback.
> 4. DMA callback gives up spinlock after copying the data, but before
> restarting DMA.
> 5. UART ISR acquires the spin lock and reads the same DMA buffer because
> DMA has not been restarted yet.
>
> The release of the spinlock during the DMA callback was introduced by
> commit 9b88748b362c ("tty: serial: tegra: drop uart_port->lock before
> calling tty_flip_buffer_push()") to fix a spinlock lock-up issue when
> calling tty_flip_buffer_push(). However, since then commit a9c3f68f3cd8
> ("tty: Fix low_latency BUG") migrated tty_flip_buffer_push() to always
> use a workqueue, allowing tty_flip_buffer_push() to be called from
> within atomic sections. Therefore, we can remove the unlocking of the
> spinlock from the DMA callback and UART ISR and this will ensure that
> the race condition no longer occurs.
>
> Reported-by: Christopher Freeman <cfreeman@xxxxxxxxxx>
> Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx>
> ---
> drivers/tty/serial/serial-tegra.c | 10 ++--------
> 1 file changed, 2 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/tty/serial/serial-tegra.c b/drivers/tty/serial/serial-tegra.c
> index cf0133ae762d..38b49f447bd7 100644
> --- a/drivers/tty/serial/serial-tegra.c
> +++ b/drivers/tty/serial/serial-tegra.c
> @@ -607,9 +607,7 @@ static void tegra_uart_rx_dma_complete(void *args)
>
> tegra_uart_handle_rx_pio(tup, port);
> if (tty) {
> - spin_unlock_irqrestore(&u->lock, flags);
> tty_flip_buffer_push(port);
> - spin_lock_irqsave(&u->lock, flags);
> tty_kref_put(tty);
> }
> tegra_uart_start_rx_dma(tup);
> @@ -622,13 +620,11 @@ done:
> spin_unlock_irqrestore(&u->lock, flags);
> }
>
> -static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup,
> - unsigned long *flags)
> +static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup)
> {
> struct dma_tx_state state;
> struct tty_struct *tty = tty_port_tty_get(&tup->uport.state->port);
> struct tty_port *port = &tup->uport.state->port;
> - struct uart_port *u = &tup->uport;
> unsigned int count;
>
> /* Deactivate flow control to stop sender */
> @@ -645,9 +641,7 @@ static void tegra_uart_handle_rx_dma(struct tegra_uart_port *tup,
>
> tegra_uart_handle_rx_pio(tup, port);
> if (tty) {
> - spin_unlock_irqrestore(&u->lock, *flags);
> tty_flip_buffer_push(port);
> - spin_lock_irqsave(&u->lock, *flags);
> tty_kref_put(tty);
> }
> tegra_uart_start_rx_dma(tup);
> @@ -714,7 +708,7 @@ static irqreturn_t tegra_uart_isr(int irq, void *data)
> iir = tegra_uart_read(tup, UART_IIR);
> if (iir & UART_IIR_NO_INT) {
> if (is_rx_int) {
> - tegra_uart_handle_rx_dma(tup, &flags);
> + tegra_uart_handle_rx_dma(tup);
> if (tup->rx_in_progress) {
> ier = tup->ier_shadow;
> ier |= (UART_IER_RLSI | UART_IER_RTOIE |
>
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
