On Wed, Feb 25, 2015 at 1:15 PM, Thierry Reding <thierry.reding@xxxxxxxxx> wrote: > On Wed, Feb 25, 2015 at 09:27:36AM -0800, Andrew Bresticker wrote: >> Hi Thierry, >> >> > Sorry for taking so awfully long to look at this. I've spent some time >> > looking at various pieces of documentation and I concluded that >> > representing the port assignment as muxing options doesn't seem right >> > after all. Instead I've come up with an alternate proposal (attached). >> > Could you take a look and see if that sounds reasonable to you? >> >> Thanks for taking a look at this. I've been meaning to pick this >> series back up, but haven't had quite enough bandwidth lately. >> >> This all looks good to me, just one comment below: >> >> > +PHY nodes: >> > +---------- >> > + >> > +An optional child node named "phys" can contain nodes describing additional >> > +properties of each PHY. Only USB3 and UTMI PHYs can be complemented in this >> > +way, in which case the name of each node must match one of the following: >> > + >> > + usb3-0, usb3-1, utmi-0, utmi-1, utmi-2 >> > + >> > +Required properties for USB3 PHYs: >> > +- nvidia,lanes: specifies the name of the lane that this USB3 PHY uses >> > +- nvidia,port: specifies the number of the USB2 port that is used for this >> > + USB3 PHY >> > + >> > +Optional properties for UTMI PHYs: >> > +- vbus-supply: regulator providing the VBUS voltage for the UTMI pad >> >> What about the HSIC PHYs? Shouldn't they be represented as PHY nodes as well? > > Yes, they could. The PCIe and SATA PHYs could as well. I haven't > included them because they currently don't take any properties. In > addition to that, perhaps some of the nvidia,hsic-* properties could be > moved into the PHY nodes, too. But they're also properties of the pin, > so keeping them in the pinmux nodes seems fine as well. > > On a slightly different topic, I've been trying to wrap my head around > the use of the nvidia,port property and my conclusion was that in fact > one of the physical ports is shared between USB2 and USB3. That is the > utmi-2 PHY and usb3-0 PHY go to the very same port. The vbus-supply > specified in the Jetson TK1 DTS would support that (it's associated with > utmi-2 but named vdd_usb3_reg, and the USB3 port doesn't work without > it). Can you confirm that? Yes, that is my understanding as well. -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
