On 11/04/2014 10:34 PM, Allen Martin wrote:
I tried booting 3.18-rc3 on jetson-tk1 and I'm seeing a hang during
boot right before user space normally comes up. I bisected the
regression back to this commit which just turns on AHCI. I don't have
any SATA device connected to the board.
I just tried this, and everything works out OK for me with 3.18-rc3 or
next-20141016 which I had lying around.
Which board revision are you using? I'm using rev D.
Which U-Boot revision are you using? Perhaps this is an issue with old
U-Boots that don't initialize the full pinmux, now that the kernel
doesn't and hence relies on U-Boot. I tested there weren't any kernel
regressions when I updated it not to program the static pinmux, but
perhaps SATA wasn't enabled when I did that.
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
