This enables the integrated SATA controller on the Tegra124 system-on-chip
on the Jetson TK1 board and adds regulators for the onboard Molex connector
commonly used to power SATA devices. The regulators are marked always-on
since they can be used for other purposes than powering SATA devices.
Signed-off-by: Mikko Perttunen <mperttunen@xxxxxxxxxx>
---
arch/arm/boot/dts/tegra124-jetson-tk1.dts | 35 +++++++++++++++++++++++++++++++
1 file changed, 35 insertions(+)
diff --git a/arch/arm/boot/dts/tegra124-jetson-tk1.dts b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
index 624b0fb..a4221e2 100644
--- a/arch/arm/boot/dts/tegra124-jetson-tk1.dts
+++ b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
@@ -1687,6 +1687,18 @@
vbus-supply = <&vdd_usb3_vbus>;
};
+ /* Serial ATA */
+ sata@0,70020000 {
+ status = "okay";
+
+ hvdd-supply = <&vdd_3v3_lp0>;
+ vddio-supply = <&vdd_1v05_run>;
+ avdd-supply = <&vdd_1v05_run>;
+
+ target-5v-supply = <&vdd_5v0_sata>;
+ target-12v-supply = <&vdd_12v0_sata>;
+ };
+
clocks {
compatible = "simple-bus";
#address-cells = <1>;
@@ -1828,6 +1840,29 @@
enable-active-high;
vin-supply = <&vdd_5v0_sys>;
};
+
+ /* Molex power connector */
+ vdd_5v0_sata: regulator@13 {
+ compatible = "regulator-fixed";
+ reg = <13>;
+ regulator-name = "+5V_SATA";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ vin-supply = <&vdd_5v0_sys>;
+ };
+
+ vdd_12v0_sata: regulator@14 {
+ compatible = "regulator-fixed";
+ reg = <14>;
+ regulator-name = "+12V_SATA";
+ regulator-min-microvolt = <12000000>;
+ regulator-max-microvolt = <12000000>;
+ gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ vin-supply = <&vdd_mux>;
+ };
};
sound {
--
1.8.1.5
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
