From: Thierry Reding <treding@xxxxxxxxxx>
This commit introduces a generic device tree binding for IOMMU devices.
Only a very minimal subset is described here, but it is enough to cover
the requirements of both the Exynos System MMU and Tegra SMMU as
discussed here:
https://lkml.org/lkml/2014/4/27/346
Signed-off-by: Thierry Reding <treding@xxxxxxxxxx>
---
Apologies for the noise, but apparently I mistyped one of the email
addresses, should be fixed now.
Changes in v2:
- add notes about "dma-ranges" property (drop note from commit message)
- document priorities of "iommus" property vs. "dma-ranges" property
- drop #iommu-cells in favour of #address-cells and #size-cells
- remove multiple-master device example
Documentation/devicetree/bindings/iommu/iommu.txt | 167 ++++++++++++++++++++++
1 file changed, 167 insertions(+)
create mode 100644 Documentation/devicetree/bindings/iommu/iommu.txt
diff --git a/Documentation/devicetree/bindings/iommu/iommu.txt b/Documentation/devicetree/bindings/iommu/iommu.txt
new file mode 100644
index 000000000000..6ce759afcc94
--- /dev/null
+++ b/Documentation/devicetree/bindings/iommu/iommu.txt
@@ -0,0 +1,167 @@
+This document describes the generic device tree binding for IOMMUs and their
+master(s).
+
+
+IOMMU device node:
+==================
+
+An IOMMU can provide the following services:
+
+* Remap address space to allow devices to access physical memory ranges that
+ they otherwise wouldn't be capable of accessing.
+
+ Example: 32-bit DMA to 64-bit physical addresses
+
+* Implement scatter-gather at page level granularity so that the device does
+ not have to.
+
+* Provide system protection against "rogue" DMA by forcing all accesses to go
+ through the IOMMU and faulting when encountering accesses to unmapped
+ address regions.
+
+* Provide address space isolation between multiple contexts.
+
+ Example: Virtualization
+
+Device nodes compatible with this binding represent hardware with some of the
+above capabilities.
+
+IOMMUs can be single-master or multiple-master. Single-master IOMMU devices
+typically have a fixed association to the master device, whereas multiple-
+master IOMMU devices can translate accesses from more than one master.
+
+The device tree node of the IOMMU device's parent bus must contain a valid
+"dma-ranges" property that describes how the physical address space of the
+IOMMU maps to memory. An empty "dma-ranges" property means that there is a
+1:1 mapping from IOMMU to memory.
+
+Required properties:
+--------------------
+- #address-cells: The number of cells in an IOMMU specifier needed to encode
+ an address.
+- #size-cells: The number of cells in an IOMMU specifier needed to represent
+ the length of an address range.
+
+Typical values for the above include:
+- #address-cells = <0>, size-cells = <0>: Single master IOMMU devices are not
+ configurable and therefore no additional information needs to be encoded in
+ the specifier. This may also apply to multiple master IOMMU devices that do
+ not allow the association of masters to be configured.
+- #address-cells = <1>, size-cells = <0>: Multiple master IOMMU devices may
+ need to be configured in order to enable translation for a given master. In
+ such cases the single address cell corresponds to the master device's ID.
+- #address-cells = <2>, size-cells = <2>: Some IOMMU devices allow the DMA
+ window for masters to be configured. The first cell of the address in this
+ may contain the master device's ID for example, while the second cell could
+ contain the start of the DMA window for the given device. The length of the
+ DMA window is specified by two additional cells.
+
+
+IOMMU master node:
+==================
+
+Devices that access memory through an IOMMU are called masters. A device can
+have multiple master interfaces (to one or more IOMMU devices).
+
+Required properties:
+--------------------
+- iommus: A list of phandle and IOMMU specifier pairs that describe the IOMMU
+ master interfaces of the device. One entry in the list describes one master
+ interface of the device.
+
+When an "iommus" property is specified in a device tree node, the IOMMU will
+be used for address translation. If a "dma-ranges" property exists in the
+device's parent node it will be ignored. An exception to this rule is if the
+referenced IOMMU is disabled, in which case the "dma-ranges" property of the
+parent shall take effect.
+
+Optional properties:
+--------------------
+- iommu-names: A list of names identifying each entry in the "iommus"
+ property.
+
+
+Notes:
+======
+
+One possible extension to the above is to use an "iommus" property along with
+a "dma-ranges" property in a bus device node (such as PCI host bridges). This
+can be useful to describe how children on the bus relate to the IOMMU if they
+are not explicitly listed in the device tree (e.g. PCI devices). However, the
+requirements of that use-case haven't been fully determined yet. Implementing
+this is therefore not recommended without further discussion and extension of
+this binding.
+
+
+Examples:
+=========
+
+Single-master IOMMU:
+--------------------
+
+ iommu {
+ #address-cells = <0>;
+ #size-cells = <0>;
+ };
+
+ master {
+ iommus = <&/iommu>;
+ };
+
+Multiple-master IOMMU with fixed associations:
+----------------------------------------------
+
+ /* multiple-master IOMMU */
+ iommu {
+ /*
+ * Masters are statically associated with this IOMMU and
+ * address translation is always enabled.
+ */
+ #address-cells = <0>;
+ #size-cells = <0>;
+ };
+
+ /* static association with IOMMU */
+ master@1 {
+ reg = <1>;
+ iommus = <&/iommu>;
+ };
+
+ /* static association with IOMMU */
+ master@2 {
+ reg = <2>;
+ iommus = <&/iommu>;
+ };
+
+Multiple-master IOMMU:
+----------------------
+
+ iommu {
+ /* the specifier represents the ID of the master */
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+
+ master {
+ /* device has master ID 42 in the IOMMU */
+ iommus = <&/iommu 42>;
+ };
+
+Multiple-master IOMMU with configurable DMA window:
+---------------------------------------------------
+
+ / {
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ iommu {
+ /* master ID, address of DMA window */
+ #address-cells = <2>;
+ #size-cells = <2>;
+ };
+
+ master {
+ /* master ID 42, 4 GiB DMA window starting at 0 */
+ iommus = <&/iommu 42 0 0x1 0x0>;
+ };
+ };
--
1.9.2
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
