On Fri, Feb 28, 2014 at 09:34:33AM -0700, Stephen Warren wrote: > On 02/27/2014 10:58 PM, Mark Brown wrote: > > On Thu, Feb 27, 2014 at 02:35:42PM -0700, Stephen Warren wrote: > >> On 02/27/2014 02:02 PM, Graeme Gregory wrote: > > > >>>> +- ti,irq-externally-inverted : If missing, the polarity of the Palmas IRQ > >>>> + output should be set to the opposite of the polarity indicated by the IRQ > >>>> + specifier in the interrupts property. If absent, the polarity should be > >>>> + configured to match. This allows the representation of an inverter between > >>>> + the Palmas IRQ output and the interrupt parent's IRQ input. > > > >>> This has got to be the wrong way to do things, all this leads to is every > >>> device doing this property in its own way and having totally inconsistent > >>> properties all meaning the same thing. > > > >>> If there is some other hardware inverting lines then there should be > >>> a generic binding for this in DT. This is not describing the palmas hardware > >>> but some external object to the palmas. > > > >> I'd be fine with removing the "ti," vendor prefix from the property > >> name, and promoting it to be a cross-device standard. > > > >> I'm not sure that many devices will need this though; most don't have > >> configurable output polarity. Still, I guess that shouldn't stop us from > >> creating standards for the cases where it is needed. > > > > It's really common for PMICs and CODECs to be able to set any interrupt > > polarity at least. > > > >> If the DT reviewers can ack the concept, I'm happy to respin the patch > >> with the more generic property name. > > > > I'm not sure that renaming the property really deals with the concerns > > though since drivers still all need to manually add support for this, > > shouldn't there be an interrupt controller described in the DT which > > just chains on to the parent with the polarity inverted to do the > > impedence match? > > I had thought of that when first dealing with this a couple years ago, > but Olof suggested that was too complicated. > > Certainly, adding an "inverting" interrupt controller into the path > would solve the problem without inventing any new concept in DT. > However, the inverter really isn't an interrupt controller in any > meaningful fashion. It has no status/mask/enable/... registers at all; > it's nothing more than an inverter gate, at least in my case. Hence, I'm > actually not convinced that adding an extra interrupt controller into > the path is correct here. > A interupt controller inline that does the inversion was my first thought but I think that is probably overkill unless there is a whole range of different interupt filtering operations. > Another alternative might be to add an extra IRQ bit in the IRQ > specifier (and something similar would be needed for GPIO specifiers) > that indicates "inversion between source and destination". This could be > queried by drivers in exactly the same way as the existing polarity/type > IRQ flags. We'd need to update each individual IRQ controller binding to > enable that flag, since each binding defines its own definition of such > flags. (although in practice since most use the same centrally suggested > flags, this wouldn't be any more than just saying yes, this binding > allows that new flag to be used). > A new flag would meet my concerns of every chip doing basic inversion in different ways. Graeme -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
