On one of my eMMC devices, I see the following results from calling
mmc_do_calc_max_discard() with various parameters:
[ 3.057263] MMC_DISCARD_ARG max_discard 1
[ 3.057266] MMC_ERASE_ARG max_discard 4096
[ 3.057267] MMC_TRIM_ARG max_discard 1
This causes mmc_calc_max_discard() to return 1, which makes the discard
IOCTL extremely slow.
For almost all my other eMMC devices, either:
* Both arguments to mmc_do_calc_max_discard() yield zero. Hence, the
discard IOCTL is not supported.
* Both arguments to mmc_do_calc_max_discard() yield some reasonable
large value. Hence, the discard IOCTL executes reasonably quickly.
Do you think that TRIM_ARG result is expected, or is the eMMC firmware
simply buggy?
If I modify mmc_calc_max_discard() to simply ignore the TRIM_ARG result
and always use the ERASE_ARG result, I see no errors when executing
discard operations from either mke2fs, or from the blkdiscard utility. I
have no idea if the discard operation is doing anything useful though.
As an aside, another eMMC device (with same manfid/oemid/name) I have
returns the same 1 for TRIM_ARG, but returns 0 for ERASE_ARG, and hence
discard is disabled, so I don't see this problem:
[ 1.835747] MMC_DISCARD_ARG max_discard 1
[ 1.839779] MMC_ERASE_ARG max_discard 0
[ 1.843791] MMC_TRIM_ARG max_discard 1
To solve my slow discard operations, I'm tempted to modify
mmc_calc_max_discard() as follows:
if (max_discard == 1)
max_discard = 0;
... but I'm not sure if that would be seen as a regression, since it'd
disable the discard operation completely on theoretically working (but
perhaps practically useless) systems.
Alternatively, perhaps I should replace:
if (mmc_can_trim(card)) {
max_trim = mmc_do_calc_max_discard(card, MMC_TRIM_ARG);
if (max_trim < max_discard)
max_discard = max_trim;
with:
if (mmc_can_trim(card)) {
max_trim = mmc_do_calc_max_discard(card, MMC_TRIM_ARG);
if (max_trim > 1 && max_trim < max_discard)
max_discard = max_trim;
Alternatively, should I install a quirk for the specific eMMC device,
which guards one of the changes above, or completely ignores the
TRIM_ARG result?
The eMMC device is question is:
manfid = 0x45
oemid = 0x100
name = SEM16G
Strangely, this is apparently a Sandisk eMMC device, yet there already
exist some quirks for a set of similarly named Sandisk devices, yet they
are triggered by manfid == 2, not 0x45. I'm not sure why Sandisk uses
two separate manufacturer IDs...
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
