On Mon, Dec 09, 2013 at 05:39:42PM +0000, Stephen Warren wrote: > On 12/09/2013 03:51 AM, Mark Rutland wrote: > > On Mon, Dec 09, 2013 at 10:32:19AM +0000, Laxman Dewangan wrote: > >> This device tree binding document describes the Tegra124 pincontrol > >> DT bindings. This document lists all valid properties, names, mux > >> options of Tegra124 pins. > >> > >> Signed-off-by: Laxman Dewangan <ldewangan@xxxxxxxxxx> > >> --- > >> Changes from V1: > >> - Referred the dt-binding header file on describing the nodes. > >> > >> .../bindings/pinctrl/nvidia,tegra124-pinmux.txt | 147 ++++++++++++++++++++ > >> 1 files changed, 147 insertions(+), 0 deletions(-) > >> create mode 100644 Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-pinmux.txt > >> > >> diff --git a/Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-pinmux.txt b/Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-pinmux.txt > >> new file mode 100644 > >> index 0000000..12ef772 > >> --- /dev/null > >> +++ b/Documentation/devicetree/bindings/pinctrl/nvidia,tegra124-pinmux.txt > >> @@ -0,0 +1,147 @@ > >> +NVIDIA Tegra124 pinmux controller > >> + > >> +The Tegra124 pinctrl binding is very similar to the Tegra20 and Tegra30 > >> +pinctrl binding, as described in nvidia,tegra20-pinmux.txt and > >> +nvidia,tegra30-pinmux.txt. In fact, this document assumes that binding as > >> +a baseline, and only documents the differences between the two bindings. > >> + > >> +Required properties: > >> +- compatible: "nvidia,tegra124-pinmux" > >> +- reg: Should contain the register physical address and length for each of > >> + the pad control and mux registers. The first bank of address must be the > >> + driver strength pad control register address and second bank address must > >> + be pinmux register address. > > > > The wording here could be improved. The first sentence implies an entry > > for each individual register but I assume these are actually banks of > > registers (the sizes in the exanple imply this). The second sentence is > > more sepcific. > > > > How about something like: > > > > reg: Should contain a list of base address and size pairs for: > > * first entry - the driver strength and pad control registers > > If this patch gets revised, please s/driver/drive/ here. Whoops. I'm too used to typing the former. > > > * second entry - the pinmux registers > > > > Are these banks well defined? Where do they end? > > Yes, the SoC includes specific banks of registers for those two types of > configuration. The banks end at whatever address contains the last > define register of that type. > > > Is there likely to be anything built as an extension of this? Does it > > possibly make sense to use reg-names? > > Any new SoC would get a new binding, since all the other configuration > parameters (lists of valid pins, groups, functions) would be different, > so there's no need for future compatibility here. > Ok, thanks for the info. Mark. -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
