On Fri, Nov 15, 2013 at 01:54:13PM -0700, Stephen Warren wrote:
> From: Stephen Warren <swarren@xxxxxxxxxx>
>
> Teh Tegra30 I2S driver currently allocates DMA FIFOs from the AHUB only
s/Teh/The/
> when an audio stream starts playback. This is theoretically nice for
> resource sharing, but makes no practical difference for any configuration
> the drivers currently support. However, this deferral prevents conversion
> to the standard DMA DT bindings, since conversion requires knowledge of
> the specific DMA channel to be allocated, which in turn depends on which
> specific FIFO was allocated.
>
> For this reason, move the FIFO allocate into probe() to allow later
s/allocate/allocation/?
[...]
> + i2s->playback_dma_data.addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
> + i2s->playback_dma_data.maxburst = 4;
> + ret = tegra30_ahub_allocate_tx_fifo(&i2s->playback_fifo_cif,
> + &i2s->playback_dma_data.addr,
> + &i2s->playback_dma_data.slave_id);
> + if (ret) {
> + dev_err(&pdev->dev, "Could not alloc TX FIFO: %d\n", ret);
> + goto err_suspend;
> + }
> + ret = tegra30_ahub_set_rx_cif_source(i2s->playback_i2s_cif,
> + i2s->playback_fifo_cif);
> + if (ret) {
> + dev_err(&pdev->dev, "Could not route TX FIFO: %d\n", ret);
> + goto err_free_tx_fifo;
> + }
> +
> + i2s->capture_dma_data.addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
> + i2s->capture_dma_data.maxburst = 4;
> + ret = tegra30_ahub_allocate_rx_fifo(&i2s->capture_fifo_cif,
> + &i2s->capture_dma_data.addr,
> + &i2s->capture_dma_data.slave_id);
> + if (ret) {
> + dev_err(&pdev->dev, "Could not alloc RX FIFO: %d\n", ret);
> + goto err_unroute_tx_fifo;
> + }
> + ret = tegra30_ahub_set_rx_cif_source(i2s->capture_fifo_cif,
> + i2s->capture_i2s_cif);
> + if (ret) {
> + dev_err(&pdev->dev, "Could not route TX FIFO: %d\n", ret);
> + goto err_free_rx_fifo;
> + }
> +
It could be useful to have these in a separate function so as not to
make the .probe() any larger. It's already pretty big as it is.
Thierry
Attachment:
pgpTtKNMDF8II.pgp
Description: PGP signature
