Hi, Jean Since no more comments on this series, could you take this series before the 3.13 merge window ? Because if without this series, the lm90 will be broken on the Tegra Dalmore board, and this problem will be get into the v3.13 release. Looking forward to your reply :) Thanks. Wei. On 10/18/2013 09:45 AM, Wei Ni wrote: > On 10/16/2013 11:20 AM, Wei Ni wrote: >> Hi, Jean >> >> Do you have any comments on this series, or will you take them ? > > Hi, Jean, will you apply this series befor the 3.13 merge window? > > Since I forgot to tell Stephen not to apply the "[PATCH 0/2] Update dts > file to support lm90 well" untile this series are accept, so if without > this change, the lm90 may be broken on the Dalmore board. > > Thanks. > Wei. > >> >> Thanks. >> Wei. >> >> On 10/07/2013 05:25 PM, Wei Ni wrote: >>> The device lm90 can be controlled by the vcc rail. >>> Add function to power on/off the vcc. >>> I will update all .dts files referencing this driver to >>> match the new requirement in my next series. >>> >>> This series is v5, previous version patches are: >>> [v4]: http://www.spinics.net/lists/lm-sensors/msg39583.html >>> [v3]: http://www.spinics.net/lists/lm-sensors/msg39503.html >>> [v2]: http://www.spinics.net/lists/arm-kernel/msg265373.html >>> [v1]: http://www.mail-archive.com/linux-tegra@xxxxxxxxxxxxxxx/msg12034.html >>> >>> Changes from v4: >>> 1. set vcc-supply as required property. >>> >>> Changes from v3: >>> 1. change to use devm_regulator_get, as per discussion in previous patches. >>> 2. just return errors when get error from regulator_get(), Mark's new dummy >>> regulator can cope with errors. >>> 3. add vendor prefix for GMT >>> 3. list manufacturer in the binding doc. >>> >>> Changes from v2: >>> 1. use devm_regulator_get_optional(), as suggested by Mark. >>> 2. remove the lm90_power_control(), enable the regulator in the probe() >>> directly, so the codes are more clear, as suggested by Alexander and Guenter. >>> 3. change the binding documentation, as per Stephen suggestion. >>> 4. couple of changes, as per previous review. >>> >>> Changes from v1: >>> 1. if get regulator failed, we should continue to run probe function, >>> not return fail. >>> 2. call regulator_put() in error handler and remove function. >>> 3. add LM90 DT binding document. >>> >>> Wei Ni (3): >>> hwmon: (lm90) Add power control >>> of: add vendor prefix for GMT >>> Documentation: dt: hwmon: add OF document for LM90 >>> >>> Documentation/devicetree/bindings/hwmon/lm90.txt | 44 ++++++++++++++++++++ >>> .../devicetree/bindings/vendor-prefixes.txt | 1 + >>> drivers/hwmon/lm90.c | 19 +++++++++ >>> 3 files changed, 64 insertions(+) >>> create mode 100644 Documentation/devicetree/bindings/hwmon/lm90.txt >>> >> > -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
