On 08/30/2013 01:24 PM, Kumar Gala wrote: > > On Aug 30, 2013, at 10:25 AM, Thierry Reding wrote: > >> Add a driver for simple panels. Such panels can have a regulator that >> provides the supply voltage and a separate GPIO to enable the panel. >> Optionally the panels can have a backlight associated with them so it >> can be enabled or disabled according to the panel's power management >> mode. >> >> Support is added for three panels: An AU Optronics 10.1" WSVGA, a >> Chunghwa Picture Tubes 10.1" WXGA and a Panasonic 10.1 WUXGA TFT LCD >> panel. >> diff --git a/Documentation/devicetree/bindings/panel/panel-simple.txt b/Documentation/devicetree/bindings/panel/panel-simple.txt >> +Required properties: >> +- compatible: should be one of: >> + - "auo,b101aw03": AU Optronics Corporation 10.1" WSVGA TFT LCD panel >> + - "cptt,claa101wb03": Chunghwa Picture Tubes Ltd. 10.1" WXGA TFT LCD panel >> + - "pc,vvx10f004b00": Panasonic Corporation 10.1" WUXGA TFT LCD panel >> + > > It would seem there should be a more generic compatible to cover the basic "panel-simple" case. I would suggest only documenting "simple-panel" here, and not documenting the specific panels at all; the panel-specific compatible values would show up simply due to the rule that all compatible values in *.dts should contain the exact HW model (e.g. "auo,b101aw03"), plus any HW they're compatible with (i.e. "simple-panel"). I'd suggest "simple-panel" rather than "panel-simple" since IIRC other simple bindings are "simple-xxx" rather than "xxx-simple". >> +Optional properties: >> +- ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing >> +- power-supply: regulator to provide the supply voltage >> +- enable-gpios: GPIO pin to enable or disable the panel >> +- backlight: phandle of the backlight device attached to the panel >> + > > If these are all optional, what does it mean to be a "panel-simple"? I think at least ddc-i2c-bus and backlight should be required properties. I suppose it might be possible for the panel to be always-on, and hence enable-gpios/power-supply could be optional? -- To unsubscribe from this list: send the line "unsubscribe linux-tegra" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
