Document the new device tree parameters for Tegra30 USB PHY.
Signed-off-by: Tuomas Tynkkynen <ttynkkynen@xxxxxxxxxx>
---
.../devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt | 15 ++++++++++++---
1 file changed, 12 insertions(+), 3 deletions(-)
diff --git a/Documentation/devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt b/Documentation/devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt
index 59c4854..8b5901d 100644
--- a/Documentation/devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt
+++ b/Documentation/devicetree/bindings/usb/nvidia,tegra20-usb-phy.txt
@@ -3,7 +3,7 @@ Tegra SOC USB PHY
The device node for Tegra SOC USB PHY:
Required properties :
- - compatible : Should be "nvidia,tegra20-usb-phy".
+ - compatible : Should be "nvidia,tegra<chip>-usb-phy".
- reg : Defines the following set of registers, in the order listed:
- The PHY's own register set.
Always present.
@@ -24,17 +24,26 @@ Required properties :
Required properties for phy_type == ulpi:
- nvidia,phy-reset-gpio : The GPIO used to reset the PHY.
-Required PHY timing params for utmi phy:
+Required PHY timing params for utmi phy, for all chips:
- nvidia,hssync-start-delay : Number of 480 Mhz clock cycles to wait before
start of sync launches RxActive
- nvidia,elastic-limit : Variable FIFO Depth of elastic input store
- nvidia,idle-wait-delay : Number of 480 Mhz clock cycles of idle to wait
before declare IDLE.
- nvidia,term-range-adj : Range adjusment on terminations
- - nvidia,xcvr-setup : HS driver output control
+ - Either one of the following for HS driver output control:
+ - nvidia,xcvr-setup : integer, uses the provided value.
+ - nvidia,xcvr-setup-use-fuses : boolean, indicates that the value is read
+ from the on-chip fuses
+ If both are provided, nvidia,xcvr-setup-use-fuses takes precedence.
- nvidia,xcvr-lsfslew : LS falling slew rate control.
- nvidia,xcvr-lsrslew : LS rising slew rate control.
+Required PHY timing params for utmi phy, only on Tegra30 and above:
+ - nvidia,xcvr-hsslew : HS slew rate control.
+ - nvidia,hssquelch-level : HS squelch detector level.
+ - nvidia,hsdiscon-level : HS disconnect detector level.
+
Optional properties:
- nvidia,has-legacy-mode : boolean indicates whether this controller can
operate in legacy mode (as APX 2500 / 2600). In legacy mode some
--
1.8.1.5
--
To unsubscribe from this list: send the line "unsubscribe linux-tegra" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
