On Tue, 23 Mar 2010 00:06:56 +0100 Tomasz Chmielewski <mangoo@xxxxxxxx> wrote: > Am 22.03.2010 23:26, Mike Christie wrote: > > Hi, > > > > Is it possible to set the iSNS settings: > > > > iSNSServerIP > > iSNS > > iSNSServerPort > > iSNSAccessControl > > > > in targets.conf? > > I'm afraid not yet. > > Could you provide: > > 1) example tgtadm command lines for each of above settings (perhaps for > a full target configuration, or even two), tgtadm --op update --mode sys --name iSNSServerIP -v 192.168.11.133 tgtadm --op update --mode sys --name iSNS -v On tgtadm --op update --mode sys --name iSNSServerPort -v 3205 tgtadm --op update --mode sys --name iSNSAccessControl -v Off > 2) is the order important how these commands are used (i.e. one must be > run before the other)? Yes, we need to finish all the iSNS configurations before we start iSNS service. That is, we need to finish everything before executing the following command: tgtadm --op update --mode sys --name iSNS -v On Note that we also need to finish all the iSNS configurations before we create the first target. -- To unsubscribe from this list: send the line "unsubscribe stgt" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
