ATM the atomisp driver does not call s_power() at all when no s_input
ioctl() is done by the application. This breaks older sensor drivers
which rely on s_power() for power-management.
Some drivers have worked around this, e.g. commit c5fafbadaeae ("media:
atomisp: gc0310: Power on sensor from set_fmt() callback") and
commit b3118a942c82 ("media: atomisp: ov2722: Power on sensor from
set_fmt() callback"), but this really should be fixed in the atomisp
driver itself, so that all old drivers can work.
A logical place to call s_power() would be from atomisp_start_streaming() /
atomisp_stop_streaming(). But some older drivers, e.g. the atomisp-ov2722
driver already write mode related registers on set_fmt() instead of waiting
on stream on. So the s_power(1) needs to happen at the first set_fmt().
Add an atomisp_s_sensor_power(..., 1) call just before calling set_fmt()
for this. If the power was already enabled through e.g. a s_input ioctl
atomisp_s_sensor_power() will skip calling the s_power() v4l2-subdev-op
a second time.
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
drivers/staging/media/atomisp/pci/atomisp_cmd.c | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/drivers/staging/media/atomisp/pci/atomisp_cmd.c b/drivers/staging/media/atomisp/pci/atomisp_cmd.c
index 6b8ff9f1ae63..83a15a2d358e 100644
--- a/drivers/staging/media/atomisp/pci/atomisp_cmd.c
+++ b/drivers/staging/media/atomisp/pci/atomisp_cmd.c
@@ -3760,6 +3760,17 @@ static int atomisp_set_sensor_crop_and_fmt(struct atomisp_device *isp,
if (!input->camera)
return -EINVAL;
+ /*
+ * Some old sensor drivers already write the registers on set_fmt
+ * instead of on stream on, power on the sensor now (on newer
+ * sensor drivers the s_power op is a no-op).
+ */
+ if (which == V4L2_SUBDEV_FORMAT_ACTIVE) {
+ ret = atomisp_s_sensor_power(isp, isp->asd.input_curr, 1);
+ if (ret)
+ return ret;
+ }
+
sd_state = (which == V4L2_SUBDEV_FORMAT_TRY) ? input->try_sd_state :
input->camera->active_state;
if (sd_state)
--
2.44.0
