On Fri, Apr 07, 2023 at 11:02:05PM +0200, Philipp Hortmann wrote:
> When loading the driver for rtl8192e, the W_DISABLE# switch is working as
> intended. But when the WLAN is turned off in software and then turned on
> again the W_DISABLE# does not work anymore.
>
> Reason for this is that in the function _rtl92e_dm_check_rf_ctrl_gpio()
> checking this every two seconds is an conditional return.
>
> if (priv->bfirst_after_down) {
> priv->bfirst_after_down = true; // PH: useless line
> return;
> }
>
> tmp1byte = rtl92e_readb(dev, GPI); // PH: GPI for W_DISABLE#
>
> bfirst_after_down is set true when switching the WLAN off in software. But
> it is not set to false again when WLAN is turned on again.
>
Is there a question here? You're like the expert on this driver and you
seem to have figured out the solution... I'm confused.
regards,
dan carpenter
