Re: [PATCH v2 63/66] staging: media: Add support for the Allwinner A31 ISP

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Paul,

Thank you for the patch.

On Sat, Feb 05, 2022 at 07:54:26PM +0100, Paul Kocialkowski wrote:
> Some Allwinner platforms come with an Image Signal Processor, which
> supports various features in order to enhance and transform data
> received by image sensors into good-looking pictures. In most cases,
> the data is raw bayer, which gets internally converted to RGB and
> finally YUV, which is what the hardware produces.
> 
> This driver supports ISPs that are similar to the A31 ISP, which was
> the first standalone ISP found in Allwinner platforms. Simpler ISP
> blocks were found in the A10 and A20, where they are tied to a CSI
> controller. Newer generations of Allwinner SoCs (starting with the
> H6, H616, etc) come with a new camera subsystem and revised ISP.
> Even though these previous and next-generation ISPs are somewhat
> similar to the A31 ISP, they have enough significant differences to
> be out of the scope of this driver.
> 
> While the ISP supports many features, including 3A and many
> enhancement blocks, this implementation is limited to the following:
> - V3s (V3/S3) platform support;
> - Bayer media bus formats as input;

Greyscale formats would also be nice to have, if the hardware can
support that (it mostly just requires the ability to disable the CFA
interpolation).

> - Semi-planar YUV (NV12/NV21) as output;

Packed YUV would also be useful if the hardware supports it.

> - Debayering with per-component gain and offset configuration;
> - 2D noise filtering with configurable coefficients.
> 
> Since many features are missing from the associated uAPI, the driver
> is aimed to integrate staging until all features are properly
> described.
> 
> On the technical side, it uses the v4l2 and media controller APIs,
> with a video node for capture, a processor subdev and a video node
> for parameters submission. A specific uAPI structure and associated
> v4l2 meta format are used to configure parameters of the supported
> modules.
> 
> One particular thing about the hardware is that configuration for
> module registers needs to be stored in a DMA buffer and gets copied
> to actual registers by the hardware at the next vsync, when instructed
> by a flag. This is handled by the "state" mechanism in the driver.
> 
> Signed-off-by: Paul Kocialkowski <paul.kocialkowski@xxxxxxxxxxx>
> ---
>  drivers/staging/media/sunxi/Kconfig           |   1 +
>  drivers/staging/media/sunxi/Makefile          |   1 +
>  drivers/staging/media/sunxi/sun6i-isp/Kconfig |  13 +
>  .../staging/media/sunxi/sun6i-isp/Makefile    |   4 +
>  .../staging/media/sunxi/sun6i-isp/sun6i_isp.c | 572 +++++++++++++
>  .../staging/media/sunxi/sun6i-isp/sun6i_isp.h |  86 ++
>  .../media/sunxi/sun6i-isp/sun6i_isp_capture.c | 751 ++++++++++++++++++
>  .../media/sunxi/sun6i-isp/sun6i_isp_capture.h |  78 ++
>  .../media/sunxi/sun6i-isp/sun6i_isp_params.c  | 573 +++++++++++++
>  .../media/sunxi/sun6i-isp/sun6i_isp_params.h  |  52 ++
>  .../media/sunxi/sun6i-isp/sun6i_isp_proc.c    | 599 ++++++++++++++
>  .../media/sunxi/sun6i-isp/sun6i_isp_proc.h    |  61 ++
>  .../media/sunxi/sun6i-isp/sun6i_isp_reg.h     | 275 +++++++
>  .../sunxi/sun6i-isp/uapi/sun6i-isp-config.h   |  43 +

Could you add a TODO file to list the issues that need to be fixed for
the driver to move out of staging ? I'll already propose one entry:

- Add support in libcamera

This isn't required to merge the driver in staging as long as ABI
compatibility doesn't need to be preserved until the driver is moved out
of staging.

>  14 files changed, 3109 insertions(+)
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/Kconfig
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/Makefile
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp.c
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp.h
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_capture.c
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_capture.h
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_params.c
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_params.h
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_proc.c
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_proc.h
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/sun6i_isp_reg.h
>  create mode 100644 drivers/staging/media/sunxi/sun6i-isp/uapi/sun6i-isp-config.h

[snip]

-- 
Regards,

Laurent Pinchart




[Index of Archives]     [Linux Driver Development]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux