There is an explicitly dependency between modulation and bit rate configurations. To ensure proper validation of input value for the set_bit_rate routine, we must ensure that modulation has been set before. This patch ensure that set_modulation is always called before set_bit_rate for both RX and TX routines Signed-off-by: Paulo Miguel Almeida <paulo.miguel.almeida.rodenas@xxxxxxxxx> --- drivers/staging/pi433/pi433_if.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/staging/pi433/pi433_if.c b/drivers/staging/pi433/pi433_if.c index f9f86e2c44a9..17ff51f6a9da 100644 --- a/drivers/staging/pi433/pi433_if.c +++ b/drivers/staging/pi433/pi433_if.c @@ -167,10 +167,10 @@ rf69_set_rx_cfg(struct pi433_device *dev, struct pi433_rx_cfg *rx_cfg) ret = rf69_set_frequency(dev->spi, rx_cfg->frequency); if (ret < 0) return ret; - ret = rf69_set_bit_rate(dev->spi, rx_cfg->bit_rate); + ret = rf69_set_modulation(dev->spi, rx_cfg->modulation); if (ret < 0) return ret; - ret = rf69_set_modulation(dev->spi, rx_cfg->modulation); + ret = rf69_set_bit_rate(dev->spi, rx_cfg->bit_rate); if (ret < 0) return ret; ret = rf69_set_antenna_impedance(dev->spi, rx_cfg->antenna_impedance); @@ -290,10 +290,10 @@ rf69_set_tx_cfg(struct pi433_device *dev, struct pi433_tx_cfg *tx_cfg) ret = rf69_set_frequency(dev->spi, tx_cfg->frequency); if (ret < 0) return ret; - ret = rf69_set_bit_rate(dev->spi, tx_cfg->bit_rate); + ret = rf69_set_modulation(dev->spi, tx_cfg->modulation); if (ret < 0) return ret; - ret = rf69_set_modulation(dev->spi, tx_cfg->modulation); + ret = rf69_set_bit_rate(dev->spi, tx_cfg->bit_rate); if (ret < 0) return ret; ret = rf69_set_deviation(dev->spi, tx_cfg->dev_frequency); -- 2.25.4
