[PATCH v2] staging: pi433: fix docs typos and references to previous struct names

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



In the comments there where some grammar mistakes and references to
struct names that have gotten renamed over time but not updated
in the comments.

Signed-off-by: Paulo Miguel Almeida <paulo.miguel.almeida.rodenas@xxxxxxxxx>
---
v2: revert identation that had been applied to the author's name (Req:
Greg k-h)
v1: https://lore.kernel.org/lkml/20210828000836.GA10188@localhost.localdomain/
---
 drivers/staging/pi433/pi433_if.h | 23 +++++++++++------------
 1 file changed, 11 insertions(+), 12 deletions(-)

diff --git a/drivers/staging/pi433/pi433_if.h b/drivers/staging/pi433/pi433_if.h
index d5c1521192c1..855f0bebdc1c 100644
--- a/drivers/staging/pi433/pi433_if.h
+++ b/drivers/staging/pi433/pi433_if.h
@@ -5,14 +5,13 @@
  * userspace interface for pi433 radio module
  *
  * Pi433 is a 433MHz radio module for the Raspberry Pi.
- * It is based on the HopeRf Module RFM69CW. Therefore inside of this
- * driver, you'll find an abstraction of the rf69 chip.
+ * It is based on the HopeRf Module RFM69CW. Therefore, inside of this
+ * driver you'll find an abstraction of the rf69 chip.
  *
- * If needed, this driver could be extended, to also support other
- * devices, basing on HopeRfs rf69.
+ * If needed this driver could also be extended to support other
+ * devices based on HopeRf rf69 as well as HopeRf modules with a similar
+ * interface such as RFM69HCW, RFM12, RFM95 and so on.
  *
- * The driver can also be extended, to support other modules of
- * HopeRf with a similar interace - e. g. RFM69HCW, RFM12, RFM95, ...
  * Copyright (C) 2016 Wolf-Entwicklungen
  *	Marcus Wolf <linux@xxxxxxxxxxxxxxxxxxxxx>
  */
@@ -33,8 +32,8 @@ enum option_on_off {
 /* IOCTL structs and commands */
 
 /**
- * struct pi433_tx_config
- * describes the configuration of the radio module for sending
+ * struct pi433_tx_cfg
+ * describes the configuration of the radio module for sending data
  * @frequency:
  * @bit_rate:
  * @modulation:
@@ -46,7 +45,7 @@ enum option_on_off {
  * @repetitions:
  *
  * ATTENTION:
- * If the contents of 'pi433_tx_config' ever change
+ * If the contents of 'pi433_tx_cfg' ever change
  * incompatibly, then the ioctl number (see define below) must change.
  *
  * NOTE: struct layout is the same in 64bit and 32bit userspace.
@@ -81,8 +80,8 @@ struct pi433_tx_cfg {
 };
 
 /**
- * struct pi433_rx_config
- * describes the configuration of the radio module for sending
+ * struct pi433_rx_cfg
+ * describes the configuration of the radio module for receiving data
  * @frequency:
  * @bit_rate:
  * @modulation:
@@ -94,7 +93,7 @@ struct pi433_tx_cfg {
  * @repetitions:
  *
  * ATTENTION:
- * If the contents of 'pi433_rx_config' ever change
+ * If the contents of 'pi433_rx_cfg' ever change
  * incompatibly, then the ioctl number (see define below) must change
  *
  * NOTE: struct layout is the same in 64bit and 32bit userspace.
-- 
2.25.4





[Index of Archives]     [Linux Driver Development]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux