Re: [PATCH -next] media: staging: media: atomisp: pci: fix error return code in atomisp_pci_probe()

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jun 17, 2021 at 03:23:29PM +0800, Yang Yingliang wrote:
> If init_atomisp_wdts() fails, atomisp_pci_probe() need return
> error code.
> 
> Reported-by: Hulk Robot <hulkci@xxxxxxxxxx>
> Signed-off-by: Yang Yingliang <yangyingliang@xxxxxxxxxx>
> ---
>  drivers/staging/media/atomisp/pci/atomisp_v4l2.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/staging/media/atomisp/pci/atomisp_v4l2.c b/drivers/staging/media/atomisp/pci/atomisp_v4l2.c
> index 948769ca6539..5de878fe798b 100644
> --- a/drivers/staging/media/atomisp/pci/atomisp_v4l2.c
> +++ b/drivers/staging/media/atomisp/pci/atomisp_v4l2.c
> @@ -1763,7 +1763,8 @@ static int atomisp_pci_probe(struct pci_dev *pdev, const struct pci_device_id *i
>  	if (err < 0)
>  		goto register_entities_fail;
>  	/* init atomisp wdts */
> -	if (init_atomisp_wdts(isp) != 0)
> +	err = init_atomisp_wdts(isp);
> +	if (err != 0)

Change this to: if (err).

Only use != 0 when you are talking about numbers or for strcmp().

	if (num != 0) // it's fine because we are talking about zero as
		      // number zero.

	if (len == 0) // fine, length is measured in numbers.

	if (err != 0) // In this case, error is not a number but either
		      // an error code or success.  It's not like -3 is
		      // worse than -2 or anything like that.  It's not
		      // a count or a measurement.

For (strcmp(a, b) != 0), the != means "a != b".

regards,
dan carpenter





[Index of Archives]     [Linux Driver Development]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux