In preparation for supporting transfer_one, which supplies the speed from the spi_transfer instead of the spi_device, convert config_op to take the speed and mode directly. Signed-off-by: Sean Anderson <sean.anderson@xxxxxxxxx> --- drivers/spi/spi-zynqmp-gqspi.c | 13 +++++-------- 1 file changed, 5 insertions(+), 8 deletions(-) diff --git a/drivers/spi/spi-zynqmp-gqspi.c b/drivers/spi/spi-zynqmp-gqspi.c index 95eea7d75f71..ba12adec8632 100644 --- a/drivers/spi/spi-zynqmp-gqspi.c +++ b/drivers/spi/spi-zynqmp-gqspi.c @@ -545,8 +545,8 @@ static inline u32 zynqmp_qspi_selectspimode(struct zynqmp_qspi *xqspi, /** * zynqmp_qspi_config_op - Configure QSPI controller for specified * transfer - * @xqspi: Pointer to the zynqmp_qspi structure - * @qspi: Pointer to the spi_device structure + * @xqspi: Pointer to the zynqmp_qspi structure + * @req_speed_hz: Requested frequency * * Sets the operational mode of QSPI controller for the next QSPI transfer and * sets the requested clock frequency. @@ -563,13 +563,10 @@ static inline u32 zynqmp_qspi_selectspimode(struct zynqmp_qspi *xqspi, * by the QSPI controller the driver will set the highest or lowest * frequency supported by controller. */ -static int zynqmp_qspi_config_op(struct zynqmp_qspi *xqspi, - struct spi_device *qspi) +static int zynqmp_qspi_config_op(struct zynqmp_qspi *xqspi, u32 req_speed_hz) { ulong clk_rate; - u32 config_reg, req_speed_hz, baud_rate_val = 0; - - req_speed_hz = qspi->max_speed_hz; + u32 config_reg, baud_rate_val = 0; if (xqspi->speed_hz != req_speed_hz) { xqspi->speed_hz = req_speed_hz; @@ -1094,7 +1091,7 @@ static int zynqmp_qspi_exec_op(struct spi_mem *mem, op->dummy.buswidth, op->data.buswidth); mutex_lock(&xqspi->op_lock); - zynqmp_qspi_config_op(xqspi, mem->spi); + zynqmp_qspi_config_op(xqspi, mem->spi->max_speed_hz); zynqmp_qspi_chipselect(mem->spi, false); genfifoentry |= xqspi->genfifocs; genfifoentry |= xqspi->genfifobus; -- 2.35.1.1320.gc452695387.dirty