Re: [PATCH v1 2/7] spi: dt-bindings: Document DT properties for QUP firmware loading

[Krzysztof Kozlowski <krzk@xxxxxxxxxx>]

On 04/12/2024 16:03, Viken Dadhaniya wrote:
> Document the 'qcom,load-firmware' and 'qcom,xfer-mode' properties to
> support SE(Serial Engine) firmware loading from the protocol driver and
> to select the data transfer mode, either GPI DMA (Generic Packet Interface)
> or non-GPI mode (PIO/CPU DMA).
> 
> SPI controller can operate in one of two modes based on the
> 'qcom,xfer-mode' property, and the firmware is loaded accordingly.
> 
> Co-developed-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx>
> Signed-off-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx>
> Signed-off-by: Viken Dadhaniya <quic_vdadhani@xxxxxxxxxxx>
> ---

My comments from I2C patch apply here, but let's keep discussion there.
Responding here just for formality.

Best regards,
Krzysztof