[PATCH 1/1] spi: spi-cadence: Enable spi refclk in slave mode

[Amit Kumar Mahapatra <amit.kumar-mahapatra@xxxxxxx>]

When spi-cadence is configured as a slave, it requires the SPI refclk to
detect the synchronization start condition while communicating with the
master. However, the spi-cadence driver never enables the SPI refclk in
slave mode, causing the refclk to remain disabled if the
"clk_ignore_unused" kernel parameter is not passed through bootargs.
As a result, the slave cannot detect data sent by the master, leading to
communication failure. Update driver to enable the SPI refclk in both
master and slave configurations.

Fixes: b1b90514eaa3 ("spi: spi-cadence: Add support for Slave mode")
Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xxxxxxx>
---
BRANCH: for-next
---
 drivers/spi/spi-cadence.c | 14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/spi/spi-cadence.c b/drivers/spi/spi-cadence.c
index 4eacf3f6e031..e07e081de5ea 100644
--- a/drivers/spi/spi-cadence.c
+++ b/drivers/spi/spi-cadence.c
@@ -601,14 +601,14 @@ static int cdns_spi_probe(struct platform_device *pdev)
 	reset_control_assert(xspi->rstc);
 	reset_control_deassert(xspi->rstc);
 
-	if (!spi_controller_is_target(ctlr)) {
-		xspi->ref_clk = devm_clk_get_enabled(&pdev->dev, "ref_clk");
-		if (IS_ERR(xspi->ref_clk)) {
-			dev_err(&pdev->dev, "ref_clk clock not found.\n");
-			ret = PTR_ERR(xspi->ref_clk);
-			goto remove_ctlr;
-		}
+	xspi->ref_clk = devm_clk_get_enabled(&pdev->dev, "ref_clk");
+	if (IS_ERR(xspi->ref_clk)) {
+		dev_err(&pdev->dev, "ref_clk clock not found.\n");
+		ret = PTR_ERR(xspi->ref_clk);
+		goto remove_ctlr;
+	}
 
+	if (!spi_controller_is_target(ctlr)) {
 		pm_runtime_use_autosuspend(&pdev->dev);
 		pm_runtime_set_autosuspend_delay(&pdev->dev, SPI_AUTOSUSPEND_TIMEOUT);
 		pm_runtime_get_noresume(&pdev->dev);
-- 
2.17.1