[PATCH] Documentation: spi: Update gpio+bitbang instruction

[Marco Sirabella <marco@xxxxxxxxxxxxx>]

The way to do this was changed in
9b00bc7b901f (spi-gpio: Rewrite to use GPIO descriptors)
and there's no real docs outlining this,
update defunct #include "spi-gpio.c" instructions

Signed-off-by: Marco Sirabella <marco@xxxxxxxxxxxxx>
---
 drivers/spi/spi-gpio.c | 17 ++++-------------
 1 file changed, 4 insertions(+), 13 deletions(-)

diff --git a/drivers/spi/spi-gpio.c b/drivers/spi/spi-gpio.c
index 909cce109bba..8c5f88f01db2 100644
--- a/drivers/spi/spi-gpio.c
+++ b/drivers/spi/spi-gpio.c
@@ -44,22 +44,13 @@ struct spi_gpio {
  * per transferred bit can make performance a problem, this code
  * is set up so that you can use it in either of two ways:
  *
- *   - The slow generic way:  set up platform_data to hold the GPIO
+ *   - The generic way:  set up platform_data to hold the GPIO
  *     numbers used for MISO/MOSI/SCK, and issue procedure calls for
  *     each of them.  This driver can handle several such busses.
  *
- *   - The quicker inlined way:  only helps with platform GPIO code
- *     that inlines operations for constant GPIOs.  This can give
- *     you tight (fast!) inner loops, but each such bus needs a
- *     new driver.  You'll define a new C file, with Makefile and
- *     Kconfig support; the C code can be a total of six lines:
- *
- *		#define DRIVER_NAME	"myboard_spi2"
- *		#define	SPI_MISO_GPIO	119
- *		#define	SPI_MOSI_GPIO	120
- *		#define	SPI_SCK_GPIO	121
- *		#define	SPI_N_CHIPSEL	4
- *		#include "spi-gpio.c"
+ *   - The inlined way:  manually set up and register a gpiod_lookup_table with
+ *     the appropriately labelled gpio pins "sck", "mosi", "miso" & an array
+ *     named "cs" before calling devm_spi_register_controller (XXX).
  */
 
 #ifndef DRIVER_NAME
-- 
2.43.2