Re: [PATCH 19/21] spi: s3c64xx: add support for google,gs101-spi

[Tudor Ambarus <tudor.ambarus@xxxxxxxxxx>]

Hi, Sam! Thanks for the review!

On 1/23/24 19:25, Sam Protsenko wrote:
> On Tue, Jan 23, 2024 at 9:34 AM Tudor Ambarus <tudor.ambarus@xxxxxxxxxx> wrote:
>>
>> Add support for GS101 SPI. All the SPI nodes on GS101 have 64 bytes
>> FIFOs, infer the FIFO size from the compatible. GS101 allows just 32bit
>> register accesses, otherwise a Serror Interrupt is raised. Do the write
>> reg accesses in 32 bits.
>>
>> Signed-off-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxx>
>> ---
> 
> I counted 3 different features in this patch. Would be better to split
> it correspondingly into 3 patches, to make patches atomic:
> 
>   1. I/O width
>   2. FIFO size

I kept these 2 in the same patch as gs101 to exemplify their use by
gs101. But I'm also fine splitting the patch in 3, will do in v2.

>   3. Adding support for gs101
> 
> And I'm not really convinced about FIFO size change.

I'll explain why it's needed below.

> 
>>  drivers/spi/spi-s3c64xx.c | 50 +++++++++++++++++++++++++++++++++------
>>  1 file changed, 43 insertions(+), 7 deletions(-)
>>
>> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
>> index 62671b2d594a..c4ddd2859ba4 100644
>> --- a/drivers/spi/spi-s3c64xx.c
>> +++ b/drivers/spi/spi-s3c64xx.c
>> @@ -20,6 +20,7 @@
>>
>>  #define MAX_SPI_PORTS                          12
>>  #define S3C64XX_SPI_QUIRK_CS_AUTO              BIT(1)
>> +#define S3C64XX_SPI_GS1O1_32BIT_REG_IO_WIDTH   BIT(2)
>>  #define AUTOSUSPEND_TIMEOUT                    2000
>>
>>  /* Registers and bit-fields */
>> @@ -131,6 +132,7 @@ struct s3c64xx_spi_dma_data {
>>   * @rx_lvl_offset: Bit offset of RX_FIFO_LVL bits in SPI_STATUS regiter.
>>   * @tx_st_done: Bit offset of TX_DONE bit in SPI_STATUS regiter.
>>   * @clk_div: Internal clock divider
>> + * @fifosize: size of the FIFO
>>   * @quirks: Bitmask of known quirks
>>   * @high_speed: True, if the controller supports HIGH_SPEED_EN bit.
>>   * @clk_from_cmu: True, if the controller does not include a clock mux and
>> @@ -149,6 +151,7 @@ struct s3c64xx_spi_port_config {
>>         int     tx_st_done;
>>         int     quirks;
>>         int     clk_div;
>> +       unsigned int fifosize;
>>         bool    high_speed;
>>         bool    clk_from_cmu;
>>         bool    clk_ioclk;
>> @@ -175,6 +178,7 @@ struct s3c64xx_spi_port_config {
>>   * @tx_dma: Local transmit DMA data (e.g. chan and direction)
>>   * @port_conf: Local SPI port configuartion data
>>   * @port_id: Port identification number
>> + * @fifosize: size of the FIFO for this port
>>   */
>>  struct s3c64xx_spi_driver_data {
>>         void __iomem                    *regs;
>> @@ -194,6 +198,7 @@ struct s3c64xx_spi_driver_data {
>>         struct s3c64xx_spi_dma_data     tx_dma;
>>         const struct s3c64xx_spi_port_config    *port_conf;
>>         unsigned int                    port_id;
>> +       unsigned int                    fifosize;
>>  };
>>
>>  static void s3c64xx_flush_fifo(struct s3c64xx_spi_driver_data *sdd)
>> @@ -403,7 +408,7 @@ static bool s3c64xx_spi_can_dma(struct spi_controller *host,
>>         struct s3c64xx_spi_driver_data *sdd = spi_controller_get_devdata(host);
>>
>>         if (sdd->rx_dma.ch && sdd->tx_dma.ch)
>> -               return xfer->len > FIFO_DEPTH(sdd);
>> +               return xfer->len > sdd->fifosize;
>>
>>         return false;
>>  }
>> @@ -447,12 +452,22 @@ static int s3c64xx_enable_datapath(struct s3c64xx_spi_driver_data *sdd,
>>                                         xfer->tx_buf, xfer->len / 4);
>>                                 break;
>>                         case 16:
>> -                               iowrite16_rep(regs + S3C64XX_SPI_TX_DATA,
>> -                                       xfer->tx_buf, xfer->len / 2);
>> +                               if (sdd->port_conf->quirks &
>> +                                   S3C64XX_SPI_GS1O1_32BIT_REG_IO_WIDTH)
>> +                                       iowrite16_32_rep(regs + S3C64XX_SPI_TX_DATA,
>> +                                                        xfer->tx_buf, xfer->len / 2);
>> +                               else
>> +                                       iowrite16_rep(regs + S3C64XX_SPI_TX_DATA,
>> +                                                     xfer->tx_buf, xfer->len / 2);
>>                                 break;
>>                         default:
>> -                               iowrite8_rep(regs + S3C64XX_SPI_TX_DATA,
>> -                                       xfer->tx_buf, xfer->len);
>> +                               if (sdd->port_conf->quirks &
>> +                                   S3C64XX_SPI_GS1O1_32BIT_REG_IO_WIDTH)
>> +                                       iowrite8_32_rep(regs + S3C64XX_SPI_TX_DATA,
>> +                                                       xfer->tx_buf, xfer->len);
>> +                               else
>> +                                       iowrite8_rep(regs + S3C64XX_SPI_TX_DATA,
>> +                                                    xfer->tx_buf, xfer->len);
>>                                 break;
>>                         }
>>                 }
>> @@ -696,7 +711,7 @@ static int s3c64xx_spi_transfer_one(struct spi_controller *host,
>>                                     struct spi_transfer *xfer)
>>  {
>>         struct s3c64xx_spi_driver_data *sdd = spi_controller_get_devdata(host);
>> -       const unsigned int fifo_len = FIFO_DEPTH(sdd);
>> +       const unsigned int fifo_len = sdd->fifosize;
>>         const void *tx_buf = NULL;
>>         void *rx_buf = NULL;
>>         int target_len = 0, origin_len = 0;
>> @@ -1145,6 +1160,11 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
>>                 sdd->port_id = pdev->id;
>>         }
>>
>> +       if (sdd->port_conf->fifosize)
>> +               sdd->fifosize = sdd->port_conf->fifosize;
>> +       else
>> +               sdd->fifosize = FIFO_DEPTH(sdd);
>> +
>>         sdd->cur_bpw = 8;
>>
>>         sdd->tx_dma.direction = DMA_MEM_TO_DEV;
>> @@ -1234,7 +1254,7 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
>>         dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Targets attached\n",
>>                                         sdd->port_id, host->num_chipselect);
>>         dev_dbg(&pdev->dev, "\tIOmem=[%pR]\tFIFO %dbytes\n",
>> -                                       mem_res, FIFO_DEPTH(sdd));
>> +                                       mem_res, sdd->fifosize);
>>
>>         pm_runtime_mark_last_busy(&pdev->dev);
>>         pm_runtime_put_autosuspend(&pdev->dev);
>> @@ -1362,6 +1382,18 @@ static const struct dev_pm_ops s3c64xx_spi_pm = {
>>                            s3c64xx_spi_runtime_resume, NULL)
>>  };
>>
>> +static const struct s3c64xx_spi_port_config gs101_spi_port_config = {
>> +       .fifosize       = 64,
> 
> I think if you rework the the .fifo_lvl_mask, replacing it with
> .fifosize, you should also do next things in this series:
>   1. Rework it for all supported (existing) chips in this driver
>   2. Provide fifosize property for each SPI node for all existing dts
> that use this driver
>   3. Get rid of .fifo_lvl_mask for good. But the compatibility with
> older kernels has to be taken into the account here as well.

We can't get rid of the .fifo_lvl_mask entirely because we need to be
backward compatible with the device tree files that we have now.

> 
> Otherwise it looks like a half attempt and not finished, only creating
> a duplicated property/struct field for the same (already existing)
> thing. Because it's completely possible to do the same using just
> .fifo_lvl_mask without introducing new fields or properties. If it

Using fifo_lvl_mask works but is wrong on multiple levels.
As the code is now, the device tree spi alias is used as an index in the
fifo_lvl_mask to determine the FIFO depth. I find it unacceptable to
have a dependency on an alias in a driver. Not specifying an alias will
make the probe fail, which is even worse. Also, the fifo_lvl_mask value
does not reflect the FIFO level reg field. This is incorrect as we use
partial register fields and is misleading. Other problem is that the
fifo_lvl_mask value is used to determine the FIFO depth which is also
incorrect. The FIFO depth is dictated by the SoC implementing the IP,
not by the FIFO_LVL register field. Having in mind these reasons I
marked the fifo_lvl_mask and the port_id as deprecated in the next
patch, we shouldn't use fifo_lvl_mask or the alias anymore.

In what concerns your first 2 points, to rework all the compatibles and
to introduce a fifosize property, I agree it would be nice to do it, but
it's not mandatory, we can work in an incremental fashion. Emphasizing
what is wrong, marking things as deprecated and guiding contributors on
how things should be handled is good too, which I tried in the next
patch. Anyway, I'll check what the reworking would involve, and if I
think it wouldn't take me a terrible amount of time, I'll do it.

> seems to much -- maybe just use .fifo_lvl_mask for now, and do all
> that reworking properly later, in a separate patch series?
> 

But that means to add gs101 and then to come with patches updating what
I just proposed, and I'm not thrilled about it.

Cheers,
ta