Previously, __spi_sync() and __spi_async() set message->spi to the spi device independently after calling __spi_validate(). __spi_validate() also would conditionally set this if it needed to split the message since it wasn't set yet. Since both __spi_sync() and __spi_async() call __spi_validate(), we can consolidate this into only setting message->spi once (unconditionally) in __spi_validate(). This will also save any future callers of __spi_validate() from also needing to set message->spi. Signed-off-by: David Lechner <dlechner@xxxxxxxxxxxx> --- drivers/spi/spi.c | 9 ++------- 1 file changed, 2 insertions(+), 7 deletions(-) diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c index bc3d7c0ce6b4..7a70ef47cdf6 100644 --- a/drivers/spi/spi.c +++ b/drivers/spi/spi.c @@ -4059,6 +4059,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) if (list_empty(&message->transfers)) return -EINVAL; + message->spi = spi; + /* * If an SPI controller does not support toggling the CS line on each * transfer (indicated by the SPI_CS_WORD flag) or we are using a GPIO @@ -4071,9 +4073,6 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) size_t maxsize = BITS_TO_BYTES(spi->bits_per_word); int ret; - /* spi_split_transfers_maxsize() requires message->spi */ - message->spi = spi; - ret = spi_split_transfers_maxsize(ctlr, message, maxsize, GFP_KERNEL); if (ret) @@ -4210,8 +4209,6 @@ static int __spi_async(struct spi_device *spi, struct spi_message *message) if (!ctlr->transfer) return -ENOTSUPP; - message->spi = spi; - SPI_STATISTICS_INCREMENT_FIELD(ctlr->pcpu_statistics, spi_async); SPI_STATISTICS_INCREMENT_FIELD(spi->pcpu_statistics, spi_async); @@ -4391,8 +4388,6 @@ static int __spi_sync(struct spi_device *spi, struct spi_message *message) if (status != 0) return status; - message->spi = spi; - SPI_STATISTICS_INCREMENT_FIELD(ctlr->pcpu_statistics, spi_sync); SPI_STATISTICS_INCREMENT_FIELD(spi->pcpu_statistics, spi_sync); -- 2.43.0