Re: [PATCH v20 1/4] usb: Add support for Intel LJCA device

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxx>]

On Mon, Oct 09, 2023 at 02:33:22PM +0800, Wentong Wu wrote:
> Implements the USB part of Intel USB-I2C/GPIO/SPI adapter device
> named "La Jolla Cove Adapter" (LJCA).
> 
> The communication between the various LJCA module drivers and the
> hardware will be muxed/demuxed by this driver. Three modules (
> I2C, GPIO, and SPI) are supported currently.
> 
> Each sub-module of LJCA device is identified by type field within
> the LJCA message header.
> 
> The sub-modules of LJCA can use ljca_transfer() to issue a transfer
> between host and hardware. And ljca_register_event_cb is exported
> to LJCA sub-module drivers for hardware event subscription.
> 
> The minimum code in ASL that covers this board is
> Scope (\_SB.PCI0.DWC3.RHUB.HS01)
>     {
>         Device (GPIO)
>         {
>             Name (_ADR, Zero)
>             Name (_STA, 0x0F)
>         }
> 
>         Device (I2C)
>         {
>             Name (_ADR, One)
>             Name (_STA, 0x0F)
>         }
> 
>         Device (SPI)
>         {
>             Name (_ADR, 0x02)
>             Name (_STA, 0x0F)
>         }
>     }

This commit message is not true anymore, or misleading at bare minimum.
The ACPI specification is crystal clear about usage _ADR and _HID, i.e.
they must NOT be used together for the same device node. So, can you
clarify how the DSDT is organized and update the commit message and
it may require (quite likely) to redesign the architecture of this
driver. Sorry I missed this from previous rounds as I was busy by
something else.

Greg, please do not promote this to the next before above will be clarified.

P.S> Using _ADR and _HID together is an immediate NAK from me.

-- 
With Best Regards,
Andy Shevchenko