Make sure that the device is not runtime suspended before explicitly disabling the clocks on probe failure and on driver unbind to avoid a clock enable-count imbalance. Fixes: 9e3a000362ae ("spi: zynqmp: Add pm runtime support") Cc: stable@xxxxxxxxxxxxxxx # 4.19 Cc: Naga Sureshkumar Relli <naga.sureshkumar.relli@xxxxxxxxxx> Cc: Shubhrajyoti Datta <shubhrajyoti.datta@xxxxxxxxxx> Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx> --- Hi Mark, This patch ended up sitting in your for-next and for-6.4 branches for a few releases but was never sent on to Linus as I reported here: https://lore.kernel.org/lkml/ZOy0l6sXyYib59ej@xxxxxxxxxxxxxxxxxxxxxxxx/ Now it appears to have been dropped from linux-next so resending. Johan drivers/spi/spi-zynqmp-gqspi.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/spi/spi-zynqmp-gqspi.c b/drivers/spi/spi-zynqmp-gqspi.c index 94d9a33d9af5..9a46b2478f4e 100644 --- a/drivers/spi/spi-zynqmp-gqspi.c +++ b/drivers/spi/spi-zynqmp-gqspi.c @@ -1340,9 +1340,9 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) return 0; clk_dis_all: - pm_runtime_put_sync(&pdev->dev); - pm_runtime_set_suspended(&pdev->dev); pm_runtime_disable(&pdev->dev); + pm_runtime_put_noidle(&pdev->dev); + pm_runtime_set_suspended(&pdev->dev); clk_disable_unprepare(xqspi->refclk); clk_dis_pclk: clk_disable_unprepare(xqspi->pclk); @@ -1366,11 +1366,15 @@ static void zynqmp_qspi_remove(struct platform_device *pdev) { struct zynqmp_qspi *xqspi = platform_get_drvdata(pdev); + pm_runtime_get_sync(&pdev->dev); + zynqmp_gqspi_write(xqspi, GQSPI_EN_OFST, 0x0); + + pm_runtime_disable(&pdev->dev); + pm_runtime_put_noidle(&pdev->dev); + pm_runtime_set_suspended(&pdev->dev); clk_disable_unprepare(xqspi->refclk); clk_disable_unprepare(xqspi->pclk); - pm_runtime_set_suspended(&pdev->dev); - pm_runtime_disable(&pdev->dev); } MODULE_DEVICE_TABLE(of, zynqmp_qspi_of_match); -- 2.41.0